When the sewing-frame is ready, with the cords set up and adjusted, the book must be collated to make sure that neither sheets nor plates have been lost or misplaced during the previous operations. Plates need special care to see that the guards go properly round the sheets next them.
Fig. 29.
The top back corner, on front and back waste end paper, should be marked. When this has been done, and all is found to be in order, the book is laid on a pressing-board behind the sewing-frame, the fore-edge towards the sewer, and the front end paper uppermost. As it is difficult to insert the needle into a section placed on the bed of the sewing-frame, it will be found convenient to sew upon a largish pressing-board, which will lie on the bed of the frame, and may have small catches to prevent it from shifting. When the board is in place, the first section (end paper) is taken in the left hand and turned over, so that the marks on the back come in the proper places against the strings. The left hand is inserted into the place where the sewing is to be, and with the right hand a needle and thread is passed through the kettle stitch mark (see [fig. 29]). It is grasped by the fingers of the left hand, is passed out through the back at the first mark on the left-hand side of the first upright cord, and pulled tight, leaving a loose end of thread at the kettle stitch. Then with the right hand it is inserted again in the same place, but from the other side of the cord, and so on round all five bands, and out again at the kettle stitch mark at the tail, using right and left hands alternately. The centre of the next section is then found, and it is sewn in the same way from tail to head, the thread being tied to the loose end hanging from the first kettle stitch. Another section is laid on and sewn, but when the kettle stitch is reached, the under thread is caught up in the way shown in [fig. 30]. These operations are repeated throughout the whole book. If the back seems likely to swell too much, the sections can be lightly tapped down with a loaded stick made for the purpose, care being taken not to drive the sections inwards, as it is difficult to get such sections out again. When all the sheets and the last end paper have been sewn on, a double catch stitch is made, and the end cut off. This method is known as flexible sewing “all along.”
Fig. 30.
