The lettering of library books is very important (see [Chapter XV]).
BINDING VERY THIN BOOKS
Books consisting of only one section may be bound as follows:—A sheet of paper to match the book, and two coloured sheets for end papers, are folded round the section, and a “waste” paper put over all. A strip of linen is pasted to the back of the waste, and the whole sewn together by stitching through the fold. The waste may be cut off and inserted with the linen in a split board, as for library bindings. The back edges of the board should be filed thin, and should not be placed quite up to the back, to allow for a little play in the joints.
The leather is put on in the ordinary way, except that the linen at the head and tail must be slit a little to allow for the turn in. If waterproof sheets are first inserted, the ends may be pasted, the boards shut, and the book nipped in the press. By substituting a piece of thin leather for the outside coloured paper, a leather joint can be made.
SCRAP-BOOKS
Scrap-books, into which autograph letters, sketches, or other papers can be pasted, may be made as follows:—Enough paper of good quality is folded up to the size desired, and pieces of the same paper, of the same height, and about two inches wide, are folded down the centre and inserted between the backs of the larger sheets, as shown at [fig. 73]. It is best not to insert these smaller pieces in the centre of the section, as they would be troublesome in sewing. If, after sewing, the book is filled up with waste paper laid between the leaves, it will make it manageable while being forwarded.
It is best to use a rather darkly-toned or coloured paper, as, if a quite white paper is used, any letters or papers that have become soiled, will look unduly dirty.
Fig. 73.