One of the most useful of all knots. It forms a loop that will neither jam nor slip and is the only knot which will not cut itself under heavy tension. It is much used on shipboard and in rigging when a loop is desired. To tie the knot, form a small loop on the standing-part leaving the end long enough for the size of the loop required. Pass the end up through the bight around the standing-part and down through the bight again. To tighten hold the loop in position and pull the standing-part. It is important that the knot should be held firmly in one position while tying for it is apt to slip before it is tightened. To join two sections together by this knot, tie a bowline in one end, then with the other end form the small loop, then pass the end through the loop of the first bowline and complete the knot. This method should always be used in joining kite cord to prevent cutting.
THE HALTER, SLIP OR RUNNING KNOT
First form a bight and then tie an overhand knot around the standing-part. An improvement in this knot for a halter knot is made by forming the overhand knot with a loop in the end which is pulled through. By pulling the end the knot is readily released.
THE SHEEPSHANK
This knot is used to shorten a rope. Take up the amount of rope to be shortened and make a half hitch around each bend as shown. If the knot is to be permanent the ends above each half hitch should be lashed.
THE CLOVE HITCH
A useful knot for quick tying and easy release. It is used in making fast the bow line of a boat in coming into a wharf, in lashing poles together, etc. Hold the standing-part in the left hand and pass the rope around the pole or stake; cross the standing-part, making a second turn around the pole, and pass the end under the last turn. In making a boat fast, form a bight with the end beneath, throw this over the top of the pile or mooring stake. Form another bight with the end on top, turn this over and throw over pile, pulling end together. This is a very secure knot which can be tied with the greatest rapidity.