Fig. 125. The woven bar
The spider is a little more complicated. It is made on an uneven number of threads, usually seven. They may be double or single. To make the whipped or double-thread spider, span the space with the thread and then whip back to the centre and connect the thread to the buttonholing again at some little distance from the first stitch. Whip back to the centre again and take a stitch directly opposite. Continue in this manner till there are five, seven, or nine threads around the centre, then proceed to weave under one and over the next thread until a good-sized spider is made. Do not make too large a spider, as it detracts from the work. An illustration for the single spider is given in the chapter on lace stitches.
Fig. 126. Blanket stitch
The blanket stitch is a favourite for working the edge of flannel skirts or quilted covers. Worsted or coarse silk can be used for it. It is made on the raw or folded edge of the material. Two stitches are long and two are short. Sometimes they are worked like a pyramid. Beginning at the base we increase each stitch till we reach the point and then decrease each stitch in length as we work back to the base on the other side ([Figure 126]).
The triangular buttonhole is a pretty stitch for a conventional design that has long narrow sections. It may also be used for working a very large simple scallop ([Figure 127]). The way we were taught in school was to mark the section to be worked in deep points. The twill of the buttonholing must come on the lines. The stitches are not very close to each other. The stitches are taken on the line across to the next line. Begin at the longest opening and make every stitch shorter. When the line is covered, turn the work so that the twill of the buttonholing touches the top of the stitches just made. If this stitch is used on the outer scallop it will be necessary to hem the material, letting the triangular buttonholing form the edge.