FIG. 15
A CHAIR SEAT.—The typical upholstered seat is undoubtedly that of the dining chair. The processes involved are very simple. A shallow rabbet should be run along the inside edges of the seat frame, say about ⅛ inch deep and ¾ inch wide. This will permit the gimp to run flush with the top of the seat frame when all work is completed.
FIG. 16
First decide on the number of lengths of webbing that will be required for the given area. Then, using the best of webbing, take one end and tack with 10-oz. tacks. If hard wood is used in the structure and it tends to split, use smaller tacks, say 8-oz. or 6-oz. Stretch the strand of webbing with the webbing stretcher, and tack as illustrated in Fig. [23].
When four tacks have been driven in cut the webbing off 1 inch beyond the row of tacks; fold over, and tack down with three tacks placed between the four previous ones. Folding the ends over rather than under is better practice, for the fold protects the webbing at the points of greatest strain. Use as many tacks as the wood will permit, for many tacks distribute the strain over all threads of the webbing. After the lengths of webbing have been attached from front to back weave lengths thru these from side to side as shown in Fig. [14], and secure in the same manner. The illustration shows the underside of the seat.
Next tack burlap over the webbing with 4-oz. tacks. Cut the burlap slightly larger than the opening, including the rabbet, and fold the edges over in tacking. Stretch the burlap slightly to prevent sagging in the opening, but not so tight that the webbing will not support practically all the weight.
FIG. 17
