Assign for Night Work the following arts. in Bowditch: 36-8-10-13-14-15-16-17-18-19-20-21-22-23-24.
WEDNESDAY LECTURE
Pelorus, Parallel Rulers, The Lead, Sounding Machine, Dividers And Log
I. The Pelorus
This is an instrument for taking bearings of distant objects, and for taking bearings of celestial bodies such as the sun, stars, etc. It consists of a circular, flat metallic ring, mounted on gimbals, upon a vertical standard. The best point to mount it is in the bow or on the bridge of the ship, where a clear view for taking bearings can be had. The center line of the pelorus should also be directly over the keel line of the ship. The inner edge of the metallic ring is engraved in degrees - the 0° or 360° and the 180° marks indicating a fore-and-aft line parallel to the keel of the ship. Within this ring a ground glass dial is pivoted. This ground glass dial has painted upon it a compass card divided into points and sub-divisions and into 360°. This dial is capable of being moved around, but can also be clamped to the outside ring. Pivoted with the glass dial and flat ring is a horizontal bar carrying at both of its extremes a sight vane. This sight vane can be clamped in any position independently of the ground glass dial, which can be moved freely beneath it. An indicator showing the direction the sight vane points can be read upon the compass card on the glass dial. If the glass dial be revolved until the degree of demarcation, which is coincident with the right ahead marking on the flat ring, is the same as that which points to the lubber's line of the ship's compass, then all directions indicated by the glass dial will be parallel to the corresponding directions of the ship's compass, and all bearings taken will be compass bearings, i.e., as though taken from the compass itself. In other words, it is just as though you took the compass out of its place in the pilot house, or wherever it is regularly situated, put it down where the pelorus is, and took a bearing from it of any object desired.
In taking a bearing by pelorus, two facts must be kept in mind. First, that when the bearing is taken, the exact heading, as shown by the ship's compass, is the heading shown by the pelorus. In other words, if the ship is heading NW, the pelorus must be set with the NW point on the lubber line when the bearing is taken of any object. Second, it must be remembered that the bearing of any object obtained from the pelorus is the bearing by compass. To get the true bearing of the same object you must make the proper corrections for Variation and Deviation. This can be compensated for by setting the glass dial at a point to the right or left of the compass heading to correspond with the compass error; then the bearing of any object will be the true bearing. But naturally, you will not be able to make compensation for these errors unless you have immediately before found the correct amount of the compass error.
Parallel Rulers
The parallel rulers need no explanation except for the way in which they are used on a chart. Supposing, for instance, you wish to steam from Pelham Bay to the red buoy off the westerly end of Great Captain's Island. Take your chart, mark by a pencil point the place left and the place to go to and draw a straight line intersecting these two points. Now place the parallel rulers along that line and slide them over until the nearest edge intersects the center of the compass rose at the bottom or side of the chart. Look along the ruler's edge to find where it cuts the circumference of the compass rose. That point on the compass rose will be the true compass course, and can be expressed in either the new or old compass, as, for instance, 60° or N 60° E. Remember, however, that this is the true course. In order to change it into the compass course of your ship, you must make the proper corrections for the compass error, i.e., Variation and Deviation and for Leeway, if any.
The Lead and Sounding Machine