Most of the energy radiated from active bodies is in the form of easily absorbed rays which are comparatively inactive photographically. These rays are difficult to study by the photographic method, as the layer of black paper which, in many cases, is required in order to absorb the phosphorescent light from active substances, cuts off at the same time most of the rays under examination. These easily absorbed rays will be shown to play a far more important part in the processes occurring in radio-active bodies than the penetrating rays which are more active photographically.
The electrical method, on the other hand, offers a rapid and accurate method of quantitatively examining the radiations. It can be used as a means of measurement of all the types of radiation emitted, excluding light waves, and is capable of accurate measurement over an extremely wide range. With proper precautions it can be used to measure effects produced by radiations of extremely small intensity.
54. Electrical Methods. The electrical methods employed in studying radio-activity are all based on the property of the radiation in question of ionizing the gas, i.e. of producing positively and negatively charged carriers throughout the volume of the gas. The discussion of the application of the ionization theory of gases to measurements of radio-activity has been given in the last chapter. It has been shown there that the essential condition to be fulfilled for comparative measurements of the intensity of the radiations is that the electrical field shall in all cases be strong enough to obtain the maximum or saturation current through the gas.
The electric field required to produce practical saturation varies with the intensity of the ionization and consequently with the activity of the preparations to be examined. For preparations which have an activity not more than 500 times that of uranium, under ordinary conditions, a field of 100 volts per cm. is sufficient to produce a practical saturation current. For very active samples of radium, it is often impossible to obtain conveniently a high enough electromotive force to give even approximate saturation. Under such conditions comparative measurement can be made by measuring the current under diminished pressure of the gas, when saturation is more readily obtained.
The method to be employed in the measurement of this ionization current depends largely on the intensity of the current to be measured. If some very active radium is spread on the lower of two insulated plates as in [Fig. 1], and a saturating electric field applied, the current may readily be measured by a sensitive galvanometer of high resistance. For example, a weight of ·45 gr. of radium chloride of activity 1000 times that of uranium oxide, spread over a plate of area 33 sq. cms., gave a maximum current of 1·1 × 10-8 amperes when the plates were 4·5 cms. apart. In this case the difference of potential to be applied to produce practical saturation was about 600 volts. Since most of the ionization is due to rays which are absorbed in passing through a few centimetres of air, the current is not much increased by widening the distance between the two plates. In cases where the current is not quite large enough for direct deflection, the current may be determined by connecting the upper insulated plate with a well insulated condenser. After charging for a definite time, say one or more minutes, the condenser is discharged through the galvanometer, and the current can readily be deduced.
55. In most cases, however, when dealing with less active substances like uranium or thorium, or with small amounts of active material, it is necessary to employ methods for measuring much smaller currents than can be detected conveniently by an ordinary galvanometer. The most convenient apparatus to employ for this purpose is one of the numerous types of quadrant electrometer or an electroscope of special design. For many observations, especially where the activity of the two substances is to be compared under constant conditions, an electroscope offers a very certain and easy method of measurement. As an example of a simple apparatus of this kind, a brief description will be given of the electroscope used by M. and Mme Curie in many of their earlier observations.
Fig. 11.
The connections are clearly seen from [Fig. 11]. The active material is placed on a plate laid on top of the fixed circular plate P, connected with the case of the instrument and with earth. The upper insulated plate P´ is connected with the insulated gold-leaf system LL´. S is an insulating support and L the gold-leaf.
The system is first charged to a suitable potential by means of the rod C. The rate of movement of the gold-leaf is observed by means of a microscope. In comparisons of the activity of two specimens, the time taken by the gold leaf to pass over a certain number of divisions of the micrometer scale in the eye-piece is observed. Since the capacity of the charged system is constant, the average rate of movement of the gold-leaf is directly proportional to the ionization current between P and P´, i.e. to the intensity of the radiation emitted by the active substance. Unless very active material is being examined, the difference of potential between P and P´ can easily be made sufficient to produce saturation.