A Text-Book of Precious Stones for Jewelers and the Gem-Loving Public

by Frank Bertram Wade

In view of these facts it will be well to consider briefly what stones, among those most in use, are sufficiently tough as well as hard, to give good service in jewels, such as rings, which are subject to rough wear. We may also consider those stones, whose softness, or brittleness, or ready cleavability, requires that they should be reserved for use only in those jewels which, because of their nature, receive less rough usage.

In order to deal with the principal gems systematically, let us consider them in the order of their hardness, beginning with the hardest gem material known, which is, of course, diamond.

Durability of the Diamond. Fortunately this king of gems possesses in addition to its great hardness, considerable toughness, and although it is readily cleavable in certain directions it nevertheless requires a notable amount of force applied in a particular direction to cause it to cleave. Although sharp knocks will occasionally flake off thin layers from diamonds when roughly worn in rings, or even in extreme cases fracture them, yet this happens but seldom and, as the enormous use of the diamond in ring mountings proves, it is entirely suitable for that purpose. It follows that, if a stone can stand ring usage, it can safely be used for any purpose for which precious stones are mounted.

The Corundum Gems. Next after the diamond in hardness come the corundum gems, i. e., ruby, sapphire, and the series of corundum gems of colors other than red and blue. These stones have no noticeable cleavage and are exceedingly tough, for minerals, as well as very hard. We have only to consider the use of impure corundum (emery) as a commercial abrasive in emery wheels, emery cloth, emery paper, etc., to see that the material is tough. Any of the corundum gems therefore may be used in any type of jewel without undue risk of wear or breakage. Customers of jewelers should, however, be cautioned against wearing ruby or sapphire rings on the same finger with a diamond ring in cases where it would be possible for the two stones to rub against each other. So much harder than the ruby is the diamond (in spite of the seeming closeness of position in Mohs's scale) that the slightest touch upon a ruby surface with a diamond will produce a pronounced scratch. The possessor of diamonds and other stones should also be cautioned against keeping them loose in the same jewel case or other container, as the shaking together may result in the scratching of the softer materials. The Arabs are said to have a legend to the effect that the diamond is an angry stone and that it should not be allowed to associate with other stones lest it scratch them.

Chrysoberyl. Passing on to the next mineral in the scale of hardness we come to chrysoberyl, which is rated as 81⁄2 on Mohs's scale. This mineral furnishes us the gem, alexandrite, which is notable for its power to change in color from green in daylight to red in artificial light. Chrysoberyl also supplies the finest cat's-eyes (when the material is of a sufficiently fibrous or tubular structure), and it further supplies the greenish-yellow stones frequently (though incorrectly) called "chrysolite" by jewelers. The material is very hard and reasonably tough and may be used in almost any suitable mounting.

Spinel. After chrysoberyl come the materials rated as about 8 in hardness. First and hardest of these is spinel, then comes true or precious topaz. The various spinels are very hard and tough stones. The rough material persists in turbulent mountain streams where weaker minerals are ground to powder, and when cut and polished, spinel will wear well in any jewel. The author has long worn a ruby spinel in a ring on the right hand and has done many things that have subjected it to hard knocks, yet it is still intact, except for a spot that accidentally came in contact with a fast-flying carborundum wheel, which of course abraded the spinel.

Topaz. The true topaz is a bit softer than spinel, and the rough crystals show a very perfect basal cleavage. That is, they will cleave in a plane parallel to the bases of the usual orthorhombic crystals. This being the case a cut topaz is very likely to be damaged by a blow or even by being dropped on a hard surface, and it would be wiser not to set such a stone in a ring unless it was to be but little used, or used by one who would not engage in rough work while wearing it. Thus a lady might wear a topaz ring on dress occasions for a long time without damaging it, but it would not do for a machinist to wear one in a ring.

Gems between 7 and 8 in Hardness. We now come to a rather long list of gem minerals ranging between 7 and 8 in hardness. Of these the principal ones are zircon, almandine garnet, and beryl (emerald and aquamarine) rated as 71⁄2 in hardness, and pyrope and hessonite garnet rated as 71⁄4 in hardness. Tourmaline and kunzite may also be included in this group as being on the average slightly above 7 in hardness.

The above minerals are all harder than quartz, and hence not subject to abrasion by the quartz dust which is everywhere present. In this respect they are suitable for fairly hard wear. The garnets are of sufficient toughness so that they may be freely used in rings—and the extensive use of thin slices of garnet to top doublets proves the suitability of the material for resisting wear. The zircon is rather more brittle and the artificially whitened zircons (known as jargoons) are especially subject to breakage when worn in rings. Fortunately jargoons are not commonly sold.

The beryl, whether emerald or aquamarine, is rather brittle. Emeralds are seldom found in river gravels. The material cannot persist in the mountain streams that bring down other and tougher minerals. The extreme beauty and value of the emerald has led to its use in the finest jewels, and the temptation is strong to set it in rings, especially in rings for ladies. If such rings are worn with the care that valuable jewels should receive they will probably last a long time without any more serious damage than the dulling of the sharp edges of the facets around the table. This slight damage can at any time be repaired by a light repolishing of the affected facets. If an emerald is already badly shattered, or as it is called "mossy" in character, it will not be wise to set it in a ring, as a slight shock might complete its fracture. What has been said about emerald applies equally to aquamarine except that the value at stake is much less and the material is usually much freer from cracks.