Fig. 422. Tokang or harpoon head taken from a whale in Cumberland Sound. (National Museum, Washington. 34069.) ⅔
An interesting specimen of this variety of harpoon head was found by Kumlien in Cumberland Sound (Fig. 422). It was taken from a whale and differs from the device of that country. The back is bent similar to that of the iron naulang and the barbs have two points each instead of one. The front part is sharply ridged. The specimen is very nicely finished. A few very old harpoon heads of the same pattern are deposited in the British Museum and were of Hudson Strait manufacture; therefore I conclude that Kumlien’s specimen is from the same part of the country.
Fig. 423. Ancient tokang or harpoon head. (In A. Sturgis’s collection, New York.)
Fig. 423 represents an ancient harpoon head of the same style, the locality of which is unfortunately unknown. The specimen is of particular interest, as it shows the method of fastening the stone to the ivory part. A similar specimen is in the collections of the British Museum; it formed part of the Sloane collection. Both these specimens show perforations at the lower end of the harpoon head which are not found in the modern ones. Probably these served for holding the harpoon head to the shaft by means of a thin line, in order to prevent the head from coming off before the seal or walrus was struck. These holes are similar to the ones shown in [Figs. 395] and [436].
The harpoon line (alirn) is attached to the tokang in the same way as the iparang is to the naulang. When it is fastened to the igimang, the bend of the tusk facilitates the disengagement of the harpoon head, which turns its back to that of the tusk. Attached to the line at the level of the ivory knob which has been mentioned is the teliqbing (Fig. 424), into the hole of which the knob fits closely. As the line from the tokang to the teliqbing is just long enough to allow it to be pulled down far enough to reach the knob, it holds shaft and head firmly together so long as the tusk remains in its position. As soon as a lateral strain is put upon the tusk the distance between the head and the knob is diminished and the teliqbing slips off, thus disengaging the line with the harpoon head from the shaft. Sometimes the teliqbing has two holes, one being used when the line is wet and longer, the other when it is dry and shorter.
