Taking a tape line, Fred sent the Italian to the other end of it, and they picked out a favourable location to measure across, making it over 11 feet at the narrowest spot from one edge to the other. Allowance was then made for bearings five feet on either side of the span, so that timbers 21 feet long would be required to cross the chasm. This width would require three string-pieces, or chords, to run across, one on each side, and one in the centre. These, covered with three-inch plank from end to end, would make a good, solid deck sufficient for all purposes. The planks were cut off seven feet long, to have the deck of the bridge, over all, exactly seven feet wide.

Among the timbers taken from the old barn were nine pieces, measuring 22 feet in length, 8 × 10 inches in section, so Fred decided to make use of three of these just as they were, without cutting, and to place them on their edges to get the most strength out of them. He then had six posts cut off the old cedar fence posts, about two feet long, which were sunk into the ground their whole length, as shown in [Fig. 18], three on each side of the creek, and the tops made level, so that a flat timber or plank would rest on them, touching each one. This plank was made nine feet long, so as to project over the posts about a foot at each end. This was, of course, the same at each end of the bridge. After the flat timbers had been laid on the ends of the posts and fastened with spikes, there were laid the three long timbers spanning the gully. The spaces between were equally divided, and then covered with three-inch planks taken from the floor of the old barn. The boards were cut off to the proper length and fastened down on the three timbers with spikes five inches long, the planks not laid close together, but kept about three-eighths of an inch apart, in order to let the water run off after a rain, as well as to allow air to circulate underneath and between the joints to prevent the planks from decay.

Fig. 18. Frame of foot-bridge

In order to make the bridge safe, it was necessary to build a rail on each side. Two pieces of timber about 20 feet long and 6 × 6 inches square were used for the rails, while posts and braces were made of timber of about the same dimensions. The bottoms of the posts were halved, so that they could be spiked or nailed to the long outside string-pieces, as shown in the illustration. Tenons were made on the top of these posts, and these fitted into mortises made in the top rails, and all were then put together and fastened with wooden pins.

Nick dug away the surplus earth from the approaches to the bridge, and made an easy grade to its deck. This completed the work all but the painting, which was left to be done some other day.

Mr. Gregg inspected the bridge, pronounced it all right, and congratulated Fred on his workmanship, at the same time saying a good word to Nick and George, both of whom had helped very much to make the effort a success.

In the evening Mr. Gregg told Fred and George that a friend of his had given him a copy of the rules to be observed when running a launch, so he asked the boys to get their note-books, and take these down as he read them out. Even Jessie, too, he thought, ought to be acquainted with the rules, as she might be called upon some time to make use of them, so three pencils were soon at work, as the father read out the following: