I append below a series of deformities observed in Mauser bullets, some of which were collected on the field of battle, but all of which were familiar to me in bullets removed from the bodies of patients, except the complete disc shape shown in fig. 29. They correspond with specimens of which I made sketches at the time of removal from the body, but which I had not the heart to retain in view of the natural wish of the patients to keep them as mementoes of their wounds.

Fig. 28.—Four common types of lateral Mauser Ricochet Bullets.

From left to right: 1. Slipper form; slight broadening and turning of tip. 2. More pronounced degree of form 1, with laceration of the mantle opposite the shoulder of the bullet. This is the weakest spot, for two reasons: the alteration in curve at this position, and the junction of the thickened point of the mantle with the thinner sides. 3. Lateral ricochet involving nearly whole length of bullet. Rupture of mantle from broadening of core opposite shoulder. 4. Similar lateral ricochet with extensive longitudinal rupture of mantle, the latter being turned out and forming a cutting 'flange.'

Slight indentations and deviations from strict symmetry of form of such degree as not seriously to influence the outline and nature of the apertures were very common. Beyond these one of the most frequent primary deformities was that we familiarly spoke of as the 'slipper form' (No. 1, fig. 28). This results from light glancing contact of the tip with a hard body: in it the mantle of the bullet is rarely fractured, and the deformity itself is of slight importance, except in so far as it may influence the direction of the wound track, which acquires a tendency to be curved. The tip of the bullet is slightly flattened and turned up, down, or to one side, according to the point struck. I saw this deformity frequently, both with Lee-Metford and Mauser bullets. Nos. 2, 3, and 4 are more pronounced degrees of the same type of deformity, accompanied by more or less extensive fissuring of the mantle. No. 4 illustrates the turning out of the longitudinally fissured mantle in such a way as to make a cutting flange. I have seen such bullets removed, and the variety is of some importance as materially increasing the cutting capabilities of the bullet, and augmenting its area of destructive action. No. 5, fig. 29, is the only form I have not seen removed, but such a bullet would account for some of the long irregular gutter wounds observed, if it retained sufficient velocity to strike with any force.

Fig. 29.—'Disc'-shaped Lateral Ricochet.

This form is of little practical importance, as the velocity retained by the bullet is low, and no perforating power would be retained. It is inserted separately in order to complete the series, shown in fig. 28.

Fig. 30 illustrates complete longitudinal fissuring of the mantle. Such mantles are common, and still more so are the opened-out sheets such as is shown still attached in fig. 29. Free mantles are often very numerous on stony ground, but are of little importance, since I never saw fragments of them removed or impacted. They probably travel a very short distance after their formation, and if they did strike would possess little power of penetration. The freed leaden cores do, however, sometimes enter the body, and some of the specimens removed have been referred to the use of expanding bullets. In all the Mauser specimens the longitudinal direction of the fissuring of the mantle is striking.