Fig. 9
A little practice in casting plaster bats will give the experience necessary for mixing plaster. When well mixed and a slight thickening is perceptible, it is poured very carefully into the cylinder, the paper shell being kept upright in the centre. (Fig. 9.) In about 20 minutes the surface of the plaster will feel warm. It is now set and the linoleum is removed. The plaster cylinder, when dry, is fitted on the mandrel, and this screwed to the lathe head. Two or three chisels are now required. (Fig. 10.) The rest on the lathe is clamped in a convenient position and a cutting chisel held as shown (Fig. 11), cutting edge up. The cylinder is revolved briskly as indicated by arrow, and the shape is roughly hollowed out. Proceed gradually until the shape begins to emerge, taking care not to cut too deeply. (Fig. 12.) Towards the finish use the calipers frequently to check the measurements.
At top and bottom about 1⁄2” waste is left (Fig. 13 A), turned straight, the actual line of top and base being slightly grooved in the plaster. The form may be pretty accurately finished with the chisels and then nicely smoothed with sandpaper. For this process the rotary movement is reversed.
Fig. 10
Fig. 11
The shape is now removed from the lathe and is ready for moulding.