There is a risk of overburning, causing a grey tint and a hard and granular texture.
A variety of lamp-black known as “carbon black” or “gas black,” has of late years assumed an important position among black pigments. It is produced in considerable quantities in the United States by the combustion of the natural gas issuing from the earth in the mineral oil regions. The soot arising from the imperfect combustion of the gaseous hydrocarbon is made to deposit itself on cooled iron surfaces. These at first were made stationary, but now take the form of revolving discs or cylinders, which are automatically cleansed of the black as fast as it is deposited. This type of lamp-black is remarkably free from mineral impurities and unburned oil, and of a full colour.
An improved lamp-black kiln has been introduced in which the use of water is dispensed with. It is shown in Figs. [9] and [10]. The furnace A, which is preferably built double, as shown, is constructed of brick lined with firebrick, with a rear wall a that divides the furnace room from the condensing room, side walls b, front c, and central dividing wall d, that divides the furnace into two long and narrow fire
Figs. 9 and 10.—American Lamp-black Kiln.
spaces. The bottom of the fire spaces e is formed by a sheet iron plate f that is supported by the walls, and the space below plate f serves as an air space through which air circulates by openings g in the front and side walls, this circulation of air tending to keep the plate f cool. The rear of the fire space e extends upward and communicates by an opening h through the wall with the condensing room. In the front wall c is an opening to each fire space e and a door i to each opening. The oil or other liquid is supplied by pipes k that enter from the outside near the rear of the fire spaces. The outer end of each pipe k is fitted with a cup-shaped receptacle l, into which the oil will run from the vertical branch of the main supply pipe m, so that the amount of oil running into each pipe k may be observed, and regulated by a cock. The pipe m feeds the oil to one or more furnaces, the supply of material to each furnace being separately regulated. In the fire spaces beneath pipes k are placed shallow cast iron drip pans o to receive the oil, and the oil running in faster than it will burn will drop while on fire into the pans o, and be spattered into small particles. These pans are changed frequently, access to them being obtained by doors i. A slide p is provided in each door i to allow of ventilation when required. The slides and doors should close air-tight. By constructing the fire space e long and narrow, the plate f is more readily kept cool, and the space in front of the point of combustion renders the smoke less liable to escape by the doors. The products of combustion pass through the opening h to the condensing room, which is lathed and plastered, and if the room is sufficiently large a number of furnaces may be fitted to discharge into the same room. This furnace is especially adapted for burning dead oil; but by using burners of suitable construction other oils may be burned, and a superior quality of lamp-black made from mitigated spirits.
A very large proportion of the lamp-black now made is derived from the combustion of creosote or anthracene oils from coal tar, or of the residues of shale-oil distillation. The form of combustion chamber varies in different works, but is typified by the following rough sketch of that in use at the Stampshaw Chemical Works ([Fig. 11]).
