When the mattress is sufficiently aired, put on the protective covering. Over this spread the lower sheet so that the middle fold of the sheet lies up and down the centre of the mattress from head to foot. Keep perfectly straight. The sheet should be long enough to have at least fourteen inches over at ends and sides to tuck in. Tuck ends under mattress at head and foot drawing tightly so that it will be smooth and firm. Now tuck under at one side, folding neatly at corners, so that they will be mitred when finished. If there is no rubber nor draw sheet to put on, go to the other side of the bed and tuck in firmly at corners. Then, pulling the middle of the sheet very tightly with one hand, push the mattress with the other and tuck the sheet under. This under sheet should be very smooth without a wrinkle in it. If it is not long enough to tuck in well at both head and foot, leave plenty at the head to tuck in securely and tuck in at the sides tightly rather than risk having it come loose at the head. Be sure, however, that the mattress is entirely covered.
When Rubber and Draw Sheets Are Used
Before going around to the other side, lay the rubber sheet over the bed, so that the top edge will be well above where the lower edge of the pillow will come. Put the draw sheet over it. Tuck both well under the mattress on that side. Then, go to the other side and tuck in the corners of the lower sheet as directed, then stretching draw, rubber, and under sheet very tightly, tuck in separately.
Next spread the upper sheet, wrong side up, leaving as much at the head to turn back over the blankets as you left in the under sheet to tuck in. Have the middle fold over that of the lower sheet. Spread the blankets so that their upper edges will be even with the upper edge of the mattress. If the blankets are not long enough to reach as far up as they should, and yet tuck under firmly at the foot, place the lower one as directed, and the upper one so that there will be enough to tuck under at the foot, and hold the others in place. Tuck in all at once the foot and lower corners, mitring the corners as you did those of the lower sheet. Pull and straighten the sheet at the top and turn back smoothly over the blankets. If the bed is not to be occupied right away, tuck in both sides, stretching well so that it will have a smooth surface. Put on the spread, having the top edge even with the top of the covers. Tuck in neatly at foot and lower corners, letting the sides hang. Shake and beat the pillows thoroughly, make smooth and even, and put in place.
To Change the Under Sheet When the Patient Is in Bed
Loosen the bedclothes, without jarring the bed. Take off covers one at a time, until only one blanket and sheet remain. (If the patient feels cold, leave as many blankets as necessary to keep her warm.) Holding blankets with one hand or having patient hold it by the top, draw off the upper sheet, being careful not to uncover the patient. Remove the pillows. Have the patient as near the side of the bed as is safe, on her side, and facing the side on which she is lying. Roll the under sheets on the side of the bed close to the patient's back, making them as flat as possible. Pleat about half of the fresh under sheet lengthwise, and place close to the soiled sheets. Tuck in the other half, at the head, foot and side, draw the rubber sheet back over this fresh sheet, arrange the fresh draw sheet in place, tuck both in at that side and roll the free part close up to the patient's back. Now lift the patient's feet over the roll of fresh and soiled linen to the freshly made part, then have her roll her body over that side. Going to the other side of the bed, remove all the soiled linen and tuck the fresh sheets in, pulling tightly, being sure that there are no wrinkles under the patient. All the time keep the patient well covered. Now, spread the upper sheet and blankets over the covering the patient has had on while the lower sheets were being changed and, having the patient hold the coverings you have just put on, draw off the others, just as you took off the top sheet at first. Finish making the bed as you would an unoccupied one.
If the Bed Is to Be Occupied at Once
If the bed is to be occupied at once the coverings should be tucked in only at foot, corners and one side, then turned back diagonally from the head to foot.
The bed clothes should never be drawn too tightly over a person in bed, or they may irritate the skin, especially at the knees and toes. Bed sores may be started in this way. Perhaps the commonest cause of bedsores is from wrinkles in the under sheets. If the spread is heavy it should not be used over a patient. Use a sheet instead to protect the blankets.