Fig. 19. Finishing marks left in handwork
Met. Mus. Acc. No. G.R.834
The fact that the Athenian potter made use of the turning process shows incidentally that he was able to make his vases to very exact measurements. This is important in connection with Jay Hambidge’s theory that Athenian pottery was carefully designed on certain geometrical principles;[9] for if the Athenian potter had confined himself merely to throwing on the wheel that would not have been possible. It is during the second process of turning that an expert potter can effect many changes in width and height or in details, and thus make his product correspond exactly with his carefully planned design. Modern potters of standing work in the same way today. They first make a drawing of a vase, full size or to scale, and then proceed to follow this drawing in every detail, using rules and calipers for their guidance. Of course it needs a great deal of skill and patience to be able to work so exactly; but Greek potters, we can be quite sure, had a good supply of both of these qualities.
Fig. 20. Unturned inside of amphora
Met. Mus. Acc. No. G.R.545
Work in sections.
So far we have spoken only of comparatively small vases, which can be thrown all in one piece. Larger vases are best thrown in sections. To throw large jars in one piece requires great physical strength, and it is very difficult to finish such jars properly on the inside and to prevent them from being unduly heavy. The section work is by no means easy. At first a drawing of the vase has to be made, either full size or to scale, and the heights of the different parts marked off. While throwing the respective pieces use must be made of measuring sticks and calipers, to obtain the right heights and diameters. The measurements should be those of the soft clay, which will of course be slightly larger than those of the final shape. About one-eighth is the average allowance for the shrinkage of the clay in drying and firing. This shrinkage will naturally be proportional; so that the relation of every part to the whole will be the same in the fired vase as in the thrown product. The joining is obtained by applying a thick slip of the same clay as was used for the vase, to act as a binder. When all the sections are in place the outside of the vase can be “turned.” If this and the foregoing processes are done skilfully the final joints will hardly be visible, even before the glaze is applied. Figs. [21], [22], [23] show the three chief stages in the making of a vase in sections.
Fig. 21. Vase thrown in sections