When both the front and the back is settled to the shape of the body, the center of each runs up and down and parallel above the seat line. The larger waist extends outside of the base and after the front is swung sidewise, to the side of the back, the front of the pants must be considered to be brought forward to the front of the body, the hinge being at the side, and when the front of the pants is swung forward with the hinge or swing fastened to the side, the centre of front is too small and must be supplied with extra width. Pants, as well as coats, are fitted from the side forward to the front and from the side backward to the back, and if the diameter of the center of the body from back to front is larger than on the normal form, the ends of the front will not reach the centre of the body in front and more waist proportion must be allowed there. The back must be considered stationary and requires no allowance behind, but may require allowance at the side if the waist is well filled up there. (See Dia. [XX].)
In case of a back or forward leaning waist, Dia. [XV] will show that the crotch must be considered stationary, and the crotch must also be considered as a hinge on which the upper body swings back and forward, and that if the backward leaning waist requires ½ inch less cloth on top of front, the top of back must receive that ½ inch again, or else the so-called back slope will become too large.
Dia. XV.
The descriptions of Dias. [XIII], [XIV] and [XV] should be well considered by every cutter. I have figured on them for over twelve years and the result is here given. Others might have done it in less time, but so far as I know, nobody has done it yet.
DIA. XVI.
Dia. [XVI] shows the front and back of equal width except the tops of each.
DIA. XVII.
This presents the small front and wide back.