Locking Arrangements.—Constantly inspect the locking arrangements of turnbuckles, bolts, etc. Pay particular attention to the control cable connections, and to all moving parts in respect of the controls.
Lubrication.—Keep all moving parts, such as pulleys, control levers, and hinges of controlling surfaces, well greased.
Special Inspection.—Apart from constantly examining the aeroplane with reference to the above points I have made, I think that, in the case of an aeroplane in constant use, it is an excellent thing to make a special inspection of every part, say, once a week. This will take from two to three hours according to the type of aeroplane. In order to carry it out methodically, the rigger should have a list of every part down to the smallest split-pin. He can then check the parts as he examines them, and nothing will be passed over. This, I know from experience, greatly increases the confidence of the pilot, and tends to produce good work in the air.
Windy Weather.—The aeroplane, when on the ground, should face the wind; and it is advisable to lash the control lever fast, so that the controlling surfaces may not be blown about and possibly damaged.
"Vetting" by Eye.—This should be practised at every opportunity, and, if persevered in, it is possible to become quite expert in diagnosing by eye faults in flight efficiency, stability, and control.
The aeroplane should be standing upon level ground, or, better than that, packed up into its "flying position."
Now stand in front of it and line up the leading edge with the main spar, rear spar, and trailing edge. Their shadows can usually be seen through the fabric. Allowance must, of course, be made for wash-in and wash-out; otherwise, the parts I have specified should be parallel with each other.
Now line up the centre part of the main-plane with the tail-plane. The latter should be symmetrical with it. Next, sight each interplane front strut with its rear strut. They should be parallel.
Then, standing on one side of the aeroplane, sight all the front struts. The one nearest to you should cover all the others. This applies to the rear struts also.
Look for distortion of leading edges, main and rear spars, trailing edges, tail-plane, and controlling surfaces.