FIG. 102.—THREE-QUARTER SHOE.
FIG. 103.—THREE-QUARTER BAR SHOE.
In the first, that portion of the bearing surface of the heel of the shoe is 'dropped' about 1/8 inch from the plane of the remainder, so that the shoe at this position does not come into contact with the foot at all (see Fig. 104).
In the second case the shoe is what is termed 'set' at the heel. Here it is the plane of the wearing surface of the shoe that is altered. The hinder portion of the required heel is thinned so that its lower surface does not come into contact with the ground. By this means the wall is freed from concussion and pressure. At the same time the upper surface of the shoe is in contact with the wall of the foot (see Fig. 105).
This 'setting' of the shoe is preferable to the method first described. It affords a greater protection to the foot, and does not allow of fragments of stone and flint getting in between the foot and the shoe, and so giving rise to further mischief.
The 'set' portion should be fitted full and long. It is obvious, too, that the animal should not be allowed to carry the shoe too long; otherwise, as the other portion of the shoe wears down to the level of the 'set' heel, pressure on the tender part of the foot will again result.