Book Trough Complete
The two end pieces should be made first with the top corners rounded off and the lower end, which is of simple design, can be cut out with a bracket saw and smoothed with a wood rasp. The mortises should then be laid out according to the sketch and cut, by first boring 3/4-in. holes and finishing with a chisel, being careful to keep all edges clean and free from slivers.
The shelf can now be made by cutting a double-key tenon at each end to fit the end pieces. The space between the two tenons at each end can be cut out with a bracket saw and finished with a rasp. The key holes should be mortised as shown in the sketch. The trough pieces are made in a similar manner, care being taken to have all tenons and mortises perfectly square and a good fit, so the trough when assembled will have a neat and workmanlike appearance. The trough can be finished in any one of the many mission finishes which are supplied by the trade for this purpose.
AN OAK SERVING TABLE
The serving table is another useful piece of furniture that can be made in mission style. This table should be made in quarter-sawed oak and stained very light. The stock order is as follows:
- 2 posts, 2 by 2 by 37 in., S-4-S.
- 2 posts, 2 by 2 by 31 in., S-4-S.
- 1 top, 1 by 21 by 40 in., S-2-S.
- 2 side rails, 3/4 by 3 by 34-1/2 in., S-2-S.
- 4 end rails, 3/4 by 3 by 15-1/2 in., S-2-S.
- 1 back panel, 3/4 by 4 by 34-1/2 in., S-2-S.
- 1 stretcher, 1 by 5 by 36-1/2 in., S-4-S.
- 1 slat, 1/2 by 1-1/2 by 36 in., S-4-S.