Remove the surplus glue and then apply a finish as desired.
For the paneling, frames will be needed about which to fasten the burlap. These may be made of 1/2-in, soft wood and the following pieces will be necessary:
- 2 pieces, 1/2 by 2 by 36 in., S-2-S.
- 2 pieces, 1/2 by 2 by 8 in., S-2-S.
- 4 pieces, 1/2 by 2 by 18 in., S-2-S.
- 4 pieces, 1/2 by 2 by 19 in., S-2-S.
Make these frames enough smaller than the openings they are to occupy to allow for burlap and tacks. These frames are held in place by putting fixed nails in the top of each frame before the burlap is attached. Holes are bored in the rails to correspond to them. The lower edges of the frames are held in place by nails inserted up through the rails upon which the frames rest.
Detail of the Frame
A FOLDING CARD TABLE
The accompanying sketch shows the details of a card table that can be folded up and carried about or stored away when not in use. We would advise making two tables at the same time, as the material for both can be purchased nearly as cheaply as for one. The material necessary for making one table is given in the following list: