Figure 68.—Shoulder chops and roasts.
Arm chops should be made first by cutting parallel to the surface made when the foreleg and breast were removed. Only two or three arm chops should be made ([fig. 69]). Blade chops are made by cutting between the ribs and sawing through the blade and backbone.
PN-5087
Figure 69.—Preparing arm chops.
To prepare a boneless shoulder, first remove the ribs and backbone by cutting closely underneath the ribs following their curvature; then cutting along and over the backbone and neck vertebrae to remove them ([fig. 70]). Start at the rear surface and cut along the lower edge of the blade bone to lift the underlying muscles exposing the blade bone and arm bone ([fig. 71]). Cut along the edges of these bones and then lift the over-lying meat and cut close to the top surface of these bones to remove them ([fig. 72]). The blade bone has a ridge which runs close to and nearly parallel to its shorter edge. Try not to cut through the skin surface when cutting over this ridge. The boneless meat should be rolled so that the shoulder “eye” is lengthwise in the roast. The shoulder “eye” is located under the flat surface of the shoulder blade. Roll the meat as tightly as possible, then tie securely with strong twine or cord ([fig. 68]). The boneless shoulder may be made into a pocket roast and stuffed with ground lamb or other dressing. The edges of the meat are laced together after stuffing.
PN-5088