Besides the boards you will need two pieces of two-inch moulding six feet long, and two pieces of three-fourths-inch about eleven feet long, to hold the glass in the doors, and three pair of hinges; also lock and key if you desire all to be secure.
Take A, divide in two, plane edges and square ends for sides.
Take C, cut two boards, each four feet two inches long, and one foot wide, for top and bottom.
THE CABINET.
From B cut two pieces that shall be six feet long, and four inches (for sides of door casing), then from remainder cut strip three and one half feet by one inch, to go behind lower moulding for hinges of E.
From board H (which is four feet by thirteen inches) cut out block at each end of one edge, three inches long by one wide.
Nail CC on to top and bottom of AA, taking care to put top and bottom (CC) on and not between uprights AA.
At point nine inches from lower C, nail board H, with the projection facing outward. On each side on front nail strips BB. You will find they fit into cuts made in H.