A —Box for coil of unexposed film. A´—Box for coil of exposed film. B —Film passing over rollers. B´—Exposed film passing over rollers. C —Cogwheel which draws out film. D —Teeth which jerk film past lens. E —Lens and film-gate. H —Cogwheel which draws in exposed film.
"It looks simple enough, doesn't it?" asked the photographer, who was explaining the making of a moving-picture play to his visitors. "Well, it is a simple idea, but it takes a very complicated and a wonderfully accurate machine to accomplish the desired result.
"In the first place our cinematography is just still photography at high speed. We have to take approximately sixteen snapshots a second, so you can see that it takes a perfect machine to move the film along fast enough so that we can get sixteen good, clear, sharp pictures only slightly bigger than a postage stamp, on our film between the ticks of your watch.
"Now if you look through the little hole at the back of the camera you will see that the scene in front of us is in the proper focus, and if you look at the little ground glass finder at the side here you will see it just the same way, except that it will be upside down. Now I will close the telescope focus at the rear so that when the film is brought down before the lens it will not be light struck."
The "threading" of the camera then began. "This little flap sticking out of this slit in the top box," continued the cinematographer, "is the end of the film, which is tightly wound up in its holder. You notice that I draw it out and thread it between these rollers, making sure that the teeth of the sprockets enter the perforations along the sides of the film. I also make sure that the sensitized side of the film is turned out, so that the light coming through the lens will strike it first. After the negative has been led over the sprockets you notice that it is allowed to make a loop of a couple of inches of slack. Then it is led into the important device we call the 'film gate.'
"You see the gate is hinged and that these little claws or fingers running in grooves take hold of the perforations. The next thing is to close the hinged gate so that the film is tightly held against the aperture, through which the light strikes it and makes the picture. Below the gate we let the negative make another loop and then thread it over another system of rollers and sprockets and so to the slit in the lower box, where the exposed negative is rolled.
"The camera is now loaded and threaded and when I give the crank by which the wheels are turned a few trial turns you can see the way the mechanism works. In the first place you must understand that the film has to be jerked down with an intermittent motion. Don't forget to look for the intermittent motion, because, after the persistence of vision, that jump and stop, jump and stop, is the most important thing in cinematography—intermittent motion!
"You can see as the crank turns that the sprockets pull the film out and guide it along its course, and the little fingers jerk it down the space of one picture, or three quarters of an inch, at each jump. When the fingers are jerking the negative down, the shutter must be closed, and when the fingers are making their back trip to take a new hold on another length of film the strip must be as still as the Washington Monument, for the shutter to open, let in the light and transfer the image before the lens to the negative."
The photographer turned his crank and all the wheels in the camera began to move. The sprockets working in the perforations pulled out the film and made the loop larger. The little fingers entered the perforations and jerked the film down, taking up some of the slack of the loop. The reason that the loop is formed is to prevent the film being torn by a hard jerk by the fingers when it is taut.
"Now if your eye were quick enough—which it is not"—said the photographer, "and you could see behind the gate, you would see a movement like the following repeated sixteen times to the second: Crank turns, top sprocket adds three quarters of an inch to the top loop, bottom sprocket takes up three quarters of an inch of bottom slack loop, fingers spring from groove and carry film down three quarters of an inch, inconceivably short pause while shutter opens and picture is taken; during this pause, while film is stationary, fingers jump back into groove, slide back to starting point without touching film and shutter closes. The shutter is a revolving disk between the lens and film, and the holes in the disk passing the negative admit the light."