1. Calculate how much ruffling of Hamburg edging will be needed for a skirt 2½ yards around.
2. Get samples of embroidery and pin to the Bulletin Board, where all the girls may see them.
3. Practice making a receiving tuck.
4. See if you can plan a section of a dust ruffle for a petticoat. Make the skirt part of brown paper with tissue for the ruffle.
Lesson 14
HOW TO MAKE A CORSET COVER
The new problem of corset cover is not difficult, if one has learned all the preceding lessons. Let us study how to trim this garment or the waist of a slip.
Some of the girls of Pleasant Valley will make combinations of corset cover and skirt, and others the corset cover (Fig. 62). They decide to use nainsook and to trim them with German valenciennes lace. About 1½ yards of cloth are necessary. They have sent for a simple pattern and will make them partly by hand. Miss James gave them the following directions:
Fig. 62.—A simple corset cover.
1. To cut. Place pattern economically. Pin and cut.
2. Baste. Pin and baste underarm seams and shoulders. Sew French seams by machine.
3. Make front laps. On left side make hem ¾ inch wide turned to wrong side. On right front make hem turned to right side ¾ inch wide. Stitch this 1⁄8 inch from each edge to form front lap. It could be run by hand if all handmade or featherstitched with tiny stitches. This lap is for the buttonholes, which are made vertically, three or four in the lap. If it is desired to conceal the buttons, make an extra strip for buttonholes and stitch under the right front lap with the stitching of hem.
4. Finish bottom. Even the bottom, and make as a finish a narrow hem ¼ inch wide.
5. Gather at waist line. In center fronts and in middle of center back, gather at the waist line to fit figure. Baste on inside of waist over these adjusted gathers a straight band ¼ inch wide, with edges turned. Baste and stitch this top and bottom to hold gathers. Waist line can, also, be finished, if desired, on right side with beading or with a band.
6. To finish top of cover and sleeves. Make the same finish as for kimono night dress. This is neat and attractive. The top of the corset cover can be gathered to fit the figure, or tiny hand or machine tucks of 1⁄8 inch in width may be run about three inches deep each side of the front laps, five or six tiny ones being made on each side, according to the amount of fullness to be taken in. The top can be finished with a Hamburg beading for ribbon, sewed on with a French seam; and then lace may be overhanded on the edge of it. The finish of the sleeves should correspond to the neck finish.
EXERCISES AND PROBLEMS