Fig. 7.—Diagrammatic cross section of a Berlese funnel. The central figure shows an arrangement for a steam coil, the lower left for an electric light.
[Fig. 7] illustrates a funnel that has proved very satisfactory; it is 15 inches from top to bottom, and the top has a diameter of 12 inches. The bottom opening, seven-eighths inch in diameter, fits into the mouth of the bottle containing the preservative. Three angled brackets or hangers are soldered inside the funnel to provide a rest for the screen, which is made of quarter-inch or eighth-inch mesh hardware cloth; the mesh used depends upon the type of sample. A battery of several funnels in a rack, [fig. 8], will allow the collector to sample several kinds of material at the same time.
If steam is used as a source of heat, the small copper lines that conduct it act as a partial support for the funnel by encircling it about halfway between the screen and the top; a piece of cloth is tied tightly over the top of the funnel to prevent the upward escape of animals. If an electric light is used for heating, it should be hung directly over the center of the funnel, no cloth should be tied over the top, and the light should have a reflector nearly as wide as the top of the funnel.
Fig. 8.—Berlese funnel in position on rack. Each funnel rests inside a double ring of copper tubing (visible at extreme lower left), through which live steam flows. The steam produces heat that dries out the sample of leaf mold in the funnel and drives animals into a bottle of preservative below. Cotton or a small rag is tamped between the end of the funnel and the mouth of the bottle to prevent escape of specimens.
Care must be taken not to heat the sample too rapidly. Otherwise, either moisture will condense in the lower part of the funnel and trap many of the animals working their way toward the bottom, or the heat will kill many of the organisms before they have an opportunity to move out of the sample. An application of heat sufficient to dry the sample in 4 or 5 days is usually satisfactory.
The Berlese funnel is extremely useful for collecting many groups of beetles (particularly Staphylinidae), thrips, springtails, many groups of parasitic Hymenoptera, ants, mites, pseudoscorpions, millipedes, centipedes, and a wide range of other minute animals that live in soil, surface cover, logs, or bark.
Collecting Berlese Samples.—Many different habitats and micro-habitats provide good samples for the Berlese funnel. You will find that, for general collecting, various types of ground cover are excellent; for leaf mold samples, scrape off and discard the dry surface leaves and scoop up the lower, rotted layers of leaves together with an inch or two of the adjacent soil. You may encounter especially good samples where leaves have blown in along the edge of a log. In such a situation, take some of the log bark with the sample. Collect rotten log samples in large hunks and break them up just before putting them in the funnel. From either standing stumps or fallen logs in which the wood is still too hard to break up, collect the loose bark, as it is often quite productive. Frequently, if you roll a log over, you may find animal runs under it; the debris and earth under and around these runs, together with animal nests, frequently give unusual catches, such as larvae and adults of fleas and rare ticks. Especially productive are samples taken from the interior of a standing hollow tree; from the bottom of the hollow you can scoop out a foot or more of fine, rotten, woody material rich in rare insects.
Certain items placed in the funnel may produce distinctive and unusual catches. Recently deserted birds’ nests will give mites and, frequently, rare beetles, flies, and their larvae; mature or overmature mushrooms and bracket fungi are often rich in beetles, thrips, and maggots; bark of living trees may produce unusual thrips, springtails, and psocids; debris from aquatic habitats and from the wet edges of ponds and tiny streams may be productive of rare aquatic and semiaquatic forms. Moss is a good source of peculiar species of springtails, thrips, and beetles; the moss should be rolled up carefully while being transported.