Church Needlework: A manual of practical instruction

by Hinda M. Hands

Linen thread may be used instead of silk, on a coloured or a white linen ground, for practice, but it is necessary for the embroidress to get used to working in floss[1] from the first, because it is always needed for the best and richest work, and it requires a great deal of practice before it can be dexterously handled. Ornamental rings, bracelets, &c., should not be worn when working with floss silk, particular attention must be given to keep the hands in good condition, clean and smooth; it is a good plan, if they are apt to get rough, to rub in one or two drops of pure glycerine after washing in hot water before drying them. The hands should then be rubbed perfectly dry with a linen towel. If, on the other hand, they are at all inclined to be moist, they should be frequently washed in water as hot as it can be borne, then dipped into cold water, rubbed dry, and lastly dusted over with boracic powder. Carbolic, sulphur, arsenical or other ‘complexion’ soaps should never be used before working with either gold or silver or very delicate silks; indeed, it is safest to use none but pure vegetable soaps as free from chemicals as possible. A fine white-linen apron with a bib and sleeves, or an ‘overall,’ should always be worn, and the work kept covered with a soft silk or linen handkerchief. Too much care cannot be taken with floss silk, as it is apt to catch in everything it comes near and is very easily damaged. For the same reason the needlefuls should not be long, and if the silk be bought in skeins it should be carefully wound at once, on smooth reels or cards, keeping a separate one for each shade, which should be duly named and numbered.

Of all the stitches which are worked with silk, I think SATIN-STITCH, with its many offshoots and variations, is the foremost both for usefulness and beauty. The smooth brightness of the surface; the clean-cut outline it makes of itself, when nicely done, requiring nothing further to finish it off; the ease with which shades and colours melt and blend in soft gradations or bold effects, make it the stitch par excellence for floss-silk work, whether coarse or fine.

The Flower marked A on the sampler is worked thus:—

Take a needleful of the palest of the three shades of blue floss and run round the traced outline of the upper portion of one of the petals. Never begin with a knot, but run a few stitches into a part that will be covered afterwards; to fasten it firmly just take a back-stitch and do not cut off the end till you have worked a few more stitches; always begin and end a needleful on the ‘right side’ of the work so as to have no loose ends at the back. Then bring the needle up from behind to the surface near the centre of the petal; set it in just over the outline at the top; draw it down with one hand and set it in with the other. (It ought to become, by practice, a matter of indifference which hand is at any time above and which below.) The next stitch must be shorter, the next longer, and so on till the edge of the petal is reached. The other half of the petal is filled in the same way, beginning from the middle, and keeping the ends of the stitches even along the top and quite irregular along the bottom of the row. The stitches should be just so close together as to make a firm clear edge without either overcrowding or thin weak places.

The next row is done with the middle shade of blue; after fastening the end of the thread, take the needle through to the back, then bring it up between the two long middle stitches and about halfway from the top, set it in again to make a stitch about the same length as the others were, and continue working in the same way; the only difference between the first row and the second being that the second is worked from the upper part downwards and that both ends of the stitches are irregular in length instead of only the lower ends. Also there will be fewer stitches in each row as they get nearer the bottom.

The number of rows required will depend on the size of the petal, so will the actual length of the stitches. To give some idea of the proportion, I will suppose this petal to be an inch and a half in length and an inch and a half in width at the widest part; the stitches would then be from a half to three-quarters of an inch long at the longest; it would take four rows of stitches, and there would be about thirty of them in the top row of the petal when using the full thickness of Pearsall’s ‘Stout Floss.’ The central stitches should all be vertical, and all the others radiating—that is, slanting outwards, towards the edge of the petal; this direction of the stitches must be very carefully managed, not to be too sudden in change, and the rows of stitches should ‘dovetail,’ as it were, into each other. In this example two rows of the middle shade are used, and only one each of the lightest and darkest.

This application of satin-stitch is known by a number of other names, such as ‘Long-and-short’ stitch, ‘Plumage’ or ‘Feather’ stitch; the latter name is rather misleading, as there is a well-known stitch of that name, quite different in appearance and method of working, in common use in linen embroidery. In reading descriptions of silk embroidery one should bear in mind that when Feather-stitch is mentioned it may mean the one described above.

B is worked in the three lightest shades of the bronze-green—Nos. 112, 113, and 113A. The method is precisely the same as in A above, only the radiation is different and requires even more care in the arrangement of the stitches. Radiation of lines from a centre follows a principle of natural growth, as anyone may observe by taking the separate petals of any similar flower; all the lines and veinings, however much branched or netted, will be seen to converge towards the point where it is inserted into the calyx. In the leaf the place where they converge is the midrib—an extended centre, so to speak—and in ‘B’ the stitches are aimed in the same direction. Imagination has to be called upon to suggest where the lines should run in the part of the leaf which turns over, but it should always be done intelligently.