This appears at first to be a very natural and an unavoidable objection, but the result of observations proves that the motion of vessels, of steamers at least, is not such as to cause the apprehended difficulty. Among the observations made on board the ‘Great Western’ steam-ship by Mr. Berkeley Claxton, under my direction, were measurements of the angles of rolling and pitching, and from these it was evident that the vessel never pitches to so great an angle as that to which she rises; such a result might indeed have been anticipated by considering the form of the vessel forward and aft, and the circumstance that a steamer is almost invariably meeting or passing the seas, or, if overtaken by them, is still going at a good rate, which reduces the relative speed of the sea; consequently, although the vessel may be frequently thrown up very violently forward, yet the stern, which has no displacement under water, settles down quietly and heavily upon the surface; or, considering it in another way, the variation of displacement at the stern is very rapid, falling off almost to nothing at a few feet below the water-line, and spreading out to a great extent at a few feet above, whilst forward the difference of displacement is comparatively small, the centre of motion, therefore, is thrown very far aft, and while the bows, which are also opposed to the first shock, are thrown alternately high out of water or plunged deeply into it, the stern floats nearly steady, the vessel resting on its broad counter nearly as the centre of motion: whatever may be the explanation such is the operation, not only as measured by instruments, but more particularly as observed since, practically.
In the ‘Great Western’ the whole cutwater and, it is said, a considerable length of keel, is frequently seen out of water from the bowsprit, while astern it is very doubtful whether more than half the stern part was ever seen; marks have been made by my direction on the rudder to observe this; as yet the 9-foot mark is the lowest seen, and this occurring rarely, and for very short intervals.
In the ‘Archimedes,’ during a voyage performed in her by Mr. Guppy from Bristol to Liverpool, and during which they were exposed on more than one occasion to violent pitching, the screw (which can be watched from the deck) never was uncovered; and Mr. Smith and others on board the ‘Archimedes,’ whose whole conduct was such as to inspire unusual confidence in all information obtained from them, assured me that such was always the case.
In the voyage to Oporto and back, in which I sent Mr. Berkeley Claxton, he made the same observation; these facts, in conjunction with previous and subsequent observations on board the ‘Great Western,’ convince me that nothing is to be feared on this head; but even if the screw were occasionally to be partly exposed, I know of no evil consequences likely to ensue, as I shall clearly point out when referring to the advantages of this propeller over the common paddle.
Fourthly, the difficulty of getting up the required number of revolutions, and the great defects of the mode employed in the ‘Archimedes.’
Upon this point certainly the ‘Archimedes’ offers but a miserable example, and the result is almost enough to prejudice the mind of any person against the whole scheme; the proportions of the gearing, as I have before stated, are so bad that the engines appear, even to the eye, to labour ineffectually to get up their speed. The required speed of the screw is not nearly attained, while the noise and tremor caused by the machinery is such as to render the vessel uninhabitable, and perfectly unfit for passengers, I should almost say for a crew. I never attached much importance to these circumstances, because I felt convinced that such a mere mechanical difficulty would by some means be overcome, if, as I confess I did not then at all anticipate, the screw itself should prove efficient.
The most simple and effectual means of overcoming all objections on these heads always appeared to me to be by the use of straps instead of gearing; and all my experience, and I have seen a great deal of the working of machinery by straps and ropes in the numerous works executed by my father, led me to the conclusion that there existed no difficulty whatever in sending the necessary power through a rope or hemp strap, but I was hardly prepared to find the result so entirely satisfactory as it has proved to be.
In an experiment made in your works at the yard, I have sent through two small whale lines, a power equal to about one-thirtieth of that which would be required in the strap if used in the new ship, and this without any slip or straining of the rope which would be injurious in practice, and without any peculiar means of ensuring adhesion to the drums; so that we have ascertained beyond doubt that sixty such whale lines upon a drum of only 4 feet 3 inches diameter is adequate to our wants, but if we suppose seventy lines of superior manufacture to that used in the experiments with a perfect mode of tightening and working upon a drum of 6 feet diameter, all of which can easily be had, it will ensure the perfect and easy working of a mode of obtaining the required number of revolutions of the screw without noise or tremor. The strap in question would be only about 3 feet or 3 feet 3 inches broad, easily replaced piecemeal, and even, if necessary, without stopping the engines.
All the difficulties enumerated under the fifth head may be considered as entirely overcome, or rather as ceasing to exist; and so far from the working of the screw involving difficulties and unavoidable friction, noise, or tremor, it may be worked with unquestionable and perfect facility, and as compared even with the best-made paddles in smooth water, the whole machine will be noiseless.
It is almost unnecessary that I should say that the screw, apart from the gearing in use on board the ‘Archimedes,’ cannot and does not produce the slightest tremor or noise—it was with some difficulty, and at least only by attentively listening, that the revolutions of the screw could be counted, even when disconnected and free from the noise of the engine or gearing and the vessel being towed, and then only from some defect in the bearings or the shaft of the screw causing a slight beat.