As to crushing appliances, I shall not say much. "Their name is legion for they are many," and the same may be said of concentrators. It may be old-fashioned, but I admit my predilection is still in favour of the stamper-battery, for the reason that though it may be slower in proportion to the power employed, it is simple and not liable to get out of order, a great advantage when one has so often to depend on men who bring to their work a supply principally of main strength and stupidity. For the same reason I prefer the old draw and lift, and plunger pumps to newer but more complicated water-lifters.
On both these points, however, I am constrained to admit that my opinion has recently been somewhat shaken.
I have lately seen two appliances which appear to mark a new era in the scientific progress of mining. One is the "Griffin Mill," the other the "Lemichel Siphon Elevateur."
The first is in some respects on the principle of the Huntingdon Mill. The latter, if the inventor may be believed and the results seem to show he can be, will be a wonderful factor in developing not only mining properties where a preponderance of water is the trouble, but also in providing an automatic, and therefore extremely cheap, mode of water-raising and supply, which in simplicity is thus far unexampled. Atmospheric pressure alone is relied on. The well-known process of the syphon is the basis, but with this essential difference, that a large proportion of the water drawn up to the apex of the syphon is super-elevated to heights regulated by the fall obtained in the outlet leg. This elevation can be repeated almost indefinitely by returning the waste water to the reservoirs.
The Lemichel Syphon is a wonderful, yet most simple application of natural force. The inlet leg of the syphon is larger in diameter than the outlet leg, and is provided at the bottom with a valve or "clack." The outlet leg has a tap at its base. At the apex are two chambers, with an intermediary valve, regulated by a counterpoise weighted lever. The first chamber has also a vertical valve and pipe.
When the tap of the outlet leg is turned, the water flows as in an ordinary syphon, but owing to the rapid automatic opening and shutting of the valve in the first chamber about 45 per cent of the water is diverted, and may be raised to a height of many feet above the top of the syphon.
It need not be impressed on practical men that if this invention will perform anything like what is claimed for it, its value can hardly be calculated. After a careful inspection of the appliance in operation, I believe it will do all that is stated.
Another invention is combined with this which, by a very small expenditure of fuel, will enable the first point of atmospheric pressure to be attained. In this way the unwatering of mines may be very inexpensively effected, or water for irrigation purposes may be raised from an almost level stream.
The Griffin Mill is a centrifugal motion crusher with one roller only, which, by an ingenious application of motive force, revolves in an opposite direction to its initial momentum, and which evolves a force of 6000 lb. against the tire, which is only 30 inches in diameter. For hard quartz the size should be increased by at least 6 inches. It is claimed for this mill that it will pulverise to a gauge of 900 holes to the square inch from 1 1/2 to 2 1/2 tons per hour, or, say roughly, 150 tons per week.
The Huntingdon mill is a good crusher and amalgamator where the material to be operated on is comparatively soft, but does not do such good work when the stone is of a hard flinty nature.