Packs.
Instructions For Assembling The Infantry Equipment, Model Of 1910.
1. The Cartridge Belt.—(a) To assemble the belt.
Place the adjusting strap on the ground, eyeleted edge to the front; place the pocket sections on the ground in prolongation of the adjusting strap, pockets down, tops of pockets to the front; insert end of adjusting strap in outer loop of metal guide, from the upper side, carry it under the middle bar and up through the inner loop; engage the wire hook on the end of adjusting strap in the eyelets; provided on the inner surface of the belt.
Adjust the belt to fit loosely about the waist—i.e., so that when buckled it may rest well down over the hip bones on the sides of the body and below the pit of the abdomen in front. Care should be taken that the adjustment be made equally from both ends of the adjusting strap, so that the center eyelet will be in the middle of the belt.
(c) To fill the belt.
Unsnap the flap of the pocket and the interior retaining strap; lay the retaining strap out flat in prolongation of the pocket, insert a clip of cartridges, points of bullets up, in front of the retaining strap; press down until the base of the clip rests on the bottom of the pocket; pass the retaining strap over the bullet points and fasten it to the outside of the pocket by means of the fastener provided; insert a second clip of cartridges, points of bullets down, in rear of the first clip; press down until the points of the bullets rest on the bottom of the pocket; close the flap of the pocket and fasten by means of the fastener provided.
The remaining nine pockets are filled in like manner.
2. To Attach The First-aid Pouch.—Attach the pouch under the second pocket of the right section of the belt by inserting one hook of the double-hook attachment in the eyelet, from the inside of the belt; pinch the base of the pocket, bringing eyelets close together, and insert the other hook in the same manner in the adjoining eyelet.