Figure 2.
Anvil.—An anvil weighing about ninety or one hundred pounds is heavy enough. An Eagle anvil of this weight will cost about $9 or $10. The body of this kind of anvil is cast iron with steel face and horn. Price per pound is about ten cents.
Barrel Planes.—These planes are now but little used, except for stocking guns or rifles which are to be fitted with full-length stocks. As this form of gun is somewhat going out of use, so the stocker’s planes are getting to be cast to one side. They are made similar to a narrow rabbet plane, but have the iron set close to the fore end. Any narrow plane with the fore end cut off to within half an inch of the opening in which the iron is placed will make a substitute for the stocker’s plane. The plane with round face is used to let in round barrels, and one with a face equal in width to the sides of an octagon barrel, for letting in such barrels. A narrow plane is used to let in the ramrod, by cutting a groove centrally in the bottom of the barrel groove. The planes used are about four in number and the cost is about seven or eight dollars for the set as sold by dealers.
Bevel.—Bevels for ascertaining and forming surfaces, not at a right angle with some certain line, can be had from one dollar upward in price. The four inch is very good size. The blade is held in position by a screw, which forms part of the joint on which the blade turns. Shown in [Fig. 3].
Figure 3.
Beveling Clamp.—These tools are generally made of about three sizes, and are used for holding hammers when filing the bevel upon the sides. They are also useful for holding lock-plates while filing the bevel on them. In the vise, work can only be conveniently held at a vertical or horizontal position; this clamp is designed to furnish a means to hold it so as to file an angle of about 45 degrees. The tool is shown in [Fig. 4]. It is held in the vise, the shoulders resting on the vise jaws. The spring between the jointed portions opens the tool when the vice jaws are opened, the closing of the vise jaws, of course, closing the clamp upon the work that is placed in it. The cost of these tools is from two to three dollars, according to size and quality.
Figure 4.