J. I. Case Friction Clutch.
The friction clutch [shown in illustration] is constructed as follows: The friction pulley is constructed with a friction ring upon its arms, the outer ring acting as a guard or protection, the friction ring being turned accurately to receive the wooden shoes attached to the driving arm; these wooden friction shoes are fitted to the outer surface of the ring as well as the inner, all being connected to one set of levers; so when force is applied to engage the friction to start the engine there is no tendency or danger of bursting the rim, as the pressure is equal on both sides of it. The pulley is keyed to the crank shaft, while the driving arm, with driving pinion secured firmly to it, runs loosely upon the shaft. Upon the hub of driving arm is placed a sliding sleeve with lever attached, which connects with toggle levers beneath the sliding pieces which contain the wooden friction shoes, the whole being operated by the sliding strap from footboard of engine near by the reverse lever. This makes a strong and convenient arrangement for transmitting power.
Many other styles of clutches are made by engine builders, adapted to their particular style of engines, a common way being to have the shoes tighten against the inner rim of the fly-wheel. This is not deemed as good an arrangement, for the reason that the pressure or strain is all outward against the rim, though their being used extensively indicates good results.
When operating a friction clutch, always draw or push the lever over gradually. By doing this the engine will start slowly and easily, while if the lever is jammed over suddenly, the engine will start with a jerk, which is liable to damage the traction gear. The latter should never be done unless absolutely necessary to get the engine out of bad places on the road.
QUESTIONS WITH ANSWERS,
Concerning the Operation and Care
of Steam Engines and Boilers.
Q. What should be done first, after receiving a new engine, to prepare it for running properly?
A. If a traction or farm engine, remove the box containing the fittings and tools, from the fire box, and see that the grates are in their proper places. Also take out the tools which are packed in the smoke box at front end of boiler. Then, with waste or rags well saturated with kerosene, turpentine or benzine, wipe off all the grease that the manufacturer has put on to protect the bright work from rusting. After this has been thoroughly done, clean every oil hole and bearing found upon the engine, of all dirt and cinders. Special attention should be given to this, as if dirt and cinders are allowed to remain, the bearings will cut and heat.