Now throw the reverse lever in the last notch in opposite end of quadrant, which would allow the engine to run “under”, then loosen the other eccentric (the eccentric rod of which is in a direct line with the valve rod), and proceed same as described when engine is running “over”, to get valve to lap both steam ports equally. Then place engine upon either center and move the eccentric in opposite direction from the other eccentric until the valve gives the ¹/₃₂ of an inch lead to steam port, fasten the eccentric and place the engine upon opposite center, and the amount of lead should be the same on both steam ports, and the valve properly set.
The valve being set, replace the steam chest cover, and secure the eccentrics perfectly tight by screwing the set-screws up hard to prevent them from slipping.
Always set the valve so as to run the engine backwards or “under” first.
TO SET VALVES OF DUPLEX PUMP.
Set the pistons at mid-stroke, and set the valves which are worked from the opposite side at mid-stroke also, and it will be right at all other points. The mid position of the valve can be obtained by moving it back and forth the amount of its lost motion, and dividing it so that the lead or opening on both sides will be the same.
ASCENDING HILLS.
Q. How do you ascend a hill with a traction engine?
A. When approaching a hill which you have to climb with a traction engine, see that about two inches of water shows in the glass gauge when engine is on a level. Open draft door wide, stir the fire and get it to burn briskly, and get up a good head of steam. Put reverse lever in last notch, then open throttle gradually, allowing just the necessary amount of steam to pass into the cylinder to keep the engine pulling steadily up the hill. Always start up the hill slowly; do not attempt to go up a hill at full speed, but go slowly and steadily, keeping the speed as uniform as possible by opening or closing the throttle as the case may be. Never attempt to go up a hill on a decreasing steam pressure, as there is a great liability to become stalled, in which case great damage may be done to the front end of flues. Always start on a rising steam pressure; then you know the boiler is making steam, which assures a steady ascent, as at every exhaust of the engine on an increasing or steady pressure the power becomes stronger, while at every exhaust on a decreasing pressure the power becomes weaker. Keep a uniform supply of water in the boiler at all times by use of either the pump or injector. Always when going up hill keep the draft door wide open until the steam gauge indicates that the pressure has risen almost to the blow-off point, then close the damper. Never allow steam to blow off when going up hill, as it will cause the water to raise and be carried over into the cylinder, greatly diminishing the power of the engine. Do not under any circumstances allow your engine to be stopped when going either up or down hill, as great damage may be done to the boiler.