In weaving the hurdle, begin randing at the middle space at the bottom. Reaching the end, twist the rod as described for a withe, but at one point only, bend it around the end picket and work back. Start a second rod before the first one is quite out, slewing the two for a short distance. Hammer the wattling down snug on the pickets with a block of wood and continue until the top is reached. It improves the hurdle to finish the edges with two selected rods paired, [Fig. 16]. A pairing may be introduced in the middle, if desired, to give the hurdle extra endurance if it is to be used as a pavement or floor. If the hurdle is not to be used at once, or if it is to be transported, it must be sewed. The sewing is done with wire, twine, or withes at each end and in the middle, with stitches about 6 ins. long, as shown in [Fig. 16]. About 40 ft. of wire is required to sew one hurdle. No. 14 is about the right size, and a coil of 100 lbs. will sew 40 hurdles. Three men should make a hurdle in 2 hours, 2 wattling and the third preparing the rods.
[1120]. Continuous hurdle.—If conditions permit the revetment to be built in place, the hurdle is made continuous for considerable lengths. The pickets may be larger; they are driven farther apart, 12 or 18 ins., and the brush may be heavier. The construction is more rapid. The pickets are driven with a little more slant than is intended and must be anchored to the parapet. A line of poles with wire attached at intervals of 2 or 3 pickets will answer. The wires should be made fast to the pickets after the wattling is done. They will interfere with the wearing if fastened sooner. Two men should make 4 yds. of continuous hurdle of ordinary height in one hour.
[1121]. Brush revetment.—Pickets may be set as above described and the brush laid inside of them without weaving, being held in place by bringing the earth up with it. In this case the anchors must be fastened before the brush laying begins. The wires are not much in the way in this operation.
[1122]. Gabion making.—A gabion is a cylindrical basket with open ends, made of brush woven on pickets or stakes as described for hurdles. The usual size is 2 ft. outside diam. and 2 ft. 9 ins. height of wattling. On account of the sharp curvature somewhat better brush is required for gabions than will do for hurdles.
The gabion form, [Fig. 17], is of wood, 21 ins. diam., with equidistant notches around the circumference, equal in number to the number of pickets to be used, usually 8 to 14, less if the brush is large and stiff, more if it is small and pliable. The notches should be of such depth that the pickets will project to 1 in. outside the circle. The pickets should be 11/4 to 13/4 ins. diam., 3 ft. 6 ins. long and sharpened, half at the small and half at the large end.
To make a gabion, the form is placed on the ground, level or nearly so, and the pickets are driven vertically in the notches, large and small ends down, alternately. The form is then raised a foot and held by placing a lashing around outside the pickets, tightened with a rack stick, [Fig. 18]. The wattling is randed or slewed from the form up. The form is then dropped down, the gabion inverted and the wattling completed. If the brush is small, uniform, and pliable, pairing will make a better wattling than randing. If not for immediate use, the gabion must be sewed as described for hurdles, the same quantity of wire being required.
Plate III