The current capacity of a storage battery depends on the area of the plates or electrodes, and in order to increase the capacity of a battery, and consequently the area, it is usual to use a number of plates connected in parallel. A number of small plates of a given area are to be preferred to two large plates of the same area, as the battery will be of a more convenient size.
Customarily there is one more negative plate than positive, so that the extreme end plates in a cell are negative, as the positive and negative plates alternate with each other when assembled.
An ignition battery usually consists of two negative plates and one positive. Cells used for power purposes have as high as sixty plates.
A single cell of storage battery should show about two volts when fairly well charged. If more than two volts are desired more cells should be connected in series. The total voltage will be equal to the number of cells, in series, multiplied by the voltage per cell. The voltage per cell should never be allowed to drop below 1.7 volts, as the cell is likely to be destroyed when operated with a low voltage. Recharge as soon as the voltage drops to 1.8 volts.
The ordinary six volt ignition battery consists of three separate cells connected in series, which are encased in one protecting box.
The plates are prevented from touching each other within the cell by means of a perforated sheet of hard rubber that is inserted in the space between the plates. The perforations allow the liquid to circulate between the plates.
The storage battery is furnished as standard equipment with several well known gas engine builders, and its use is advocated by nearly all. When used in connection with a low tension direct current magneto two independent sources of current are at hand, either of which will ignite the engine in an emergency.
With the magneto-storage battery combination, it is possible to obtain a few small lights at any time, whether the engine is running or not, and the engine is always ready to start on the first “over” with the storage battery and a good mixture.
If a magneto is not used, difficulty is sometimes experienced in obtaining a suitable source of charging current, as many localities do not possess direct current plants. Batteries may be charged from the direct current exciter in an alternating current station, or may be charged by an alternating current rectifier such as is used by automobile garages.
The principal objections to the storage cell are: inconvenience of charging; sulphating of cell when standing without a charge; ease with which the cell is ruined by short circuits; the damage caused by the spilling of the electrolyte; and the fact that the cell gives no warning of failing or discharged condition.