While possessing many points of merit, the make and break system is open to several serious objections:
1. Due to the high combustion temperature there is excessive wear of the working parts in the cylinder, this wear causes a change in the ignition timing.
2. The low voltage used in the make and break system calls for perfect contact of the electrodes in the cylinder. This contact is often interfered with or entirely prevented by the accumulation of carbonized oil and soot deposited on the surfaces.
3. The wear of the operating spindle or shaft, which passes through the cylinder wall causes leakage, which in turn causes a loss of compression in the cylinder.
4. The wear of the external operating mechanism produces a change in the timing. The edge of the fingers, wiper blades, etc., tend to cause an advance in the ignition as a general rule, with the attendant danger of broken crank shafts.
5. The system is mechanically complicated, correct operation calling for constant care as to adjustment.
All ignition apparatus wears in the course of time and changes the timing of the engine. The electrodes and push-rods wear and require readjustment. Generally the tendency of worn parts is to advance the ignition. This change in timing occurs so gradually that the operator does not notice it until the engine begins to pound, or until the efficiency has been considerably reduced.
When the engine is new it is well to mark the ignition mechanism in such a way that the relative positions of the crank and igniter will be shown at the time when the igniter trips. It will then be possible for the operator to refer to the marks at any time to tell whether his ignition is occurring at the proper time. Always mark the half-time gears when taking the engine apart for the difference of one tooth when reassembling will be sufficient to throw the engine out of time.
The usual method of marking the gears, is to center punch, or scratch one tooth on the small gear, and then mark the two teeth of the large gear that lie on either side of it. With these marks it is possible to replace the gears in their original and proper positions.
The igniter should trip, causing the electrodes to separate just before the end of the compression stroke is reached, or just before the crank reaches the inner dead center. The distance lacking the exact dead center represents the instant of time between the time of ignition and the actual pressure established by the combustion.