Placing a sheet of mica or hard rubber between the electrodes, or in the spark gap, will increase the resistance to the required degree. If the spark plug is in good condition the spark will jump from the insulated terminal to the shell when the mica is in the spark gap, but if a short circuit exists the current will go through it without causing a spark. It is assumed that the battery and coil are in good condition when making the above test.
If the electrodes or spark points are dirty they should be cleaned with fine sand paper, special attention being paid to the surfaces from which the spark issues. When reassembling the plug, see that all of the washers and gaskets are replaced and that the length of the spark gap is unchanged. A little change in the spark gap may make a great change in the spark. A good spark is blue white with a faint reddish flame surrounding it. When the discharge is intermittent or sputters in all directions, either the coil or the plug are partially short circuited. Always have a spare plug on hand.
Ordinarily the length of the gap or the distance between the electrodes should be about 1
32 inch for batteries, and a trifle less for magnetos. A silver dime is a good gauge for the gap. If the engine misfires with the coil and batteries in good condition, try the effects of shortening the gap a trifle, usually this will remedy the difficulty. Exhausted batteries may be made operative temporarily by closing up the plug gap to 1
64 inch or even less. Shortening the gap increases the heat of the spark and nothing is gained by having it over 1
32 inch.
Almost all high tension magnetos have visible safety spark gaps that show instantly the presence of an open circuit in the secondary or high tension circuit. If an open circuit exists, a stream of sparks will flow across the safety spark gap at low speed.
To determine the cylinder that is misfiring in a four cylinder engine proceed as follows:
Remove cover on spark coil, and hold down one vibrator spring firmly against the core while the engine is running.
If the engine speed is not decreased by cutting this coil out of action, it is probable that this is the coil connected to the misfiring cylinder. Now release this vibrator and proceed to the next coil, and hold its vibrator down. If this decreases the speed of the engine you may be sure that the first coil is in the defective circuit. If the vibrator buzzes on the coil under inspection the trouble will be found in the plug.
Cutting out a coil connected to an active cylinder decreases the speed of the engine. Cutting out the coil connected with a dead cylinder makes no difference.
(97) Magnetos.
A magneto is a device that converts the mechanical energy received from the engine into electrical energy, the electricity thus produced being used to ignite the charge in the engine. This appliance does away with all of the troubles incident to a rapidly deteriorating chemical battery and produces a much hotter and uniform spark. A magneto is especially desirable with multiple cylinder engines where the demand for current is almost continuous, as the amount of current delivered by the magneto has no effect on its life or upon the quality of the spark.