In the semi-Diesel engine the fuel is sprayed directly into the combustion chamber by mechanical means, thus making the fuel supply to a certain extent independent of atmospheric and temperature conditions. After the injection the spray is vaporized both by the hot walls of the combustion chamber and the heat of compression, the latter being principally instrumental in causing the ignition of the gas. In this case no electrical ignition devices are required, thus at one stroke overcoming one of the principal objections to a gas engine.
Until recently the semi-Diesel engines were confined to units of rather large size, the smallest being much larger than the engines usually used on the farm. It is now possible, however, to obtain oil engines of the fuel injection type in very small sizes, built especially for portable or semi-portable service. Not only is it possible to use a cheaper grade of fuel with this type of engine, but the fuel consumption is also less than with the carbureting type. To this may be added the advantages of an engine free from the troubles incident to the ignition and carbureting systems.
Good results may be obtained with small injection engines on oils running from kerosene (48 gravity) down to 28 gravity, the combustion in all cases being complete and without excessive carbon deposits. Little trouble is caused by variable loads as long as the speed is kept constant. Compared with gasoline, the heavier fuels are much safer to store and handle, owing to their high flash points.
The compression of the injection engine is much higher than the old carbureting kerosene engine as the compression heat is used in a great part to ignite the oil vapor. Usually the pressure is in excess of 150 pounds per square inch, the exact value being determined by the form of the combustion chamber, whether a hot bulb is used, etc. The high compression assists in increasing the economy of the engine.
Usually the piston either draws in a complete volume of pure air or draws in pure air through the greater part of the induction stroke, the spray either starting near the end of the suction stroke or during the early part of the compression. When a hot bulb is used the oil spray strikes the bulb forming vapor, the increasing compression caused by the advancing piston furnishing the air for combustion and forces the mixture into contact with the hot walls. Another type has no hot bulb, the lighter constituents of the fuel being vaporized and ignited by the compression alone, their inflammation serving to kindle the main, heavy body of the oil. In some engines, the combustion of the light constituents serves to spray the heavy oil through the valve and into the combustion chamber. Details of several of the most prominent makes of oil engines are described in an early chapter of this book.
As a rule, this class of oil engine does not run well when the speed is varied through any great range, nor when governed by a throttling type governor, since both of these conditions affect the compression. They may be either of the two or four stroke cycle type, and when of the latter they are much more successful than a two stroke cycle engine using a carbureter.
On small engines the fuel consumption will run about 0.7 pint per brake horsepower hour, this consumption decreasing on large engines to about 0.6 pint per brake horsepower hour or even less.
Oil Injection Type. Injection pump P driven by eccentric E through rods G-H draws oil from tank K through M-N and sprays it into combustion chamber R through O-Q. Amount of oil sprayed is controlled by fly-wheel governor W-W shifting E on shaft S, thus varying stroke of P. Engine is started by heating R with torch U and injecting first oil with hand lever I. A second pump supplies constant level of oil to K, level being observed in glass L. C-C is the cylinder, and F is the fly-wheel.
The accompanying diagram shows a diagram of a typical oil engine of the injection type, a pump P supplying the oil from auxiliary tank to the hot, extended combustion chamber R, this chamber being an extension of the cylinder C-C. Oil is kept at a constant level in K by an overflow pipe, the oil entering from the supply pump through pipe J, and entering the pump through M at N. By gauge glass L, the operator can tell whether he has a sufficient supply of oil.