To further facilitate the accessibility to working parts in the crank case, a secondary cover is provided which can be removed in a couple of minutes. This opening is large enough to allow the operator to reach any point within the crank case.
All cams are key-seated upon the cam shaft with double key-seats, which absolutely prevent any possibility of slipping or alteration in the timing of the engine. The exhaust and intake valves are mechanically operated. The valves are constructed with steel stem, nickel-steel heads, the whole being highly finished.
Valve cages are oil cooled, thereby eliminating all possibility of the valves overheating or warping. The valves themselves can be removed by simply unscrewing the connection. The engine is provided with a set of relief cams by which the compression can be relieved—this greatly facilitates the starting of the engine.
The piston is equipped with five self-expanding rings. Connecting rod is of drop-forged steel construction. Crank-pin bearings are made in halves and lined with shells of special metal.
A combination of mechanical force feed and splash lubrication is employed. Six force feed tubes enter the crank case, on to each bearing, and two tubes force oil into the cylinder. The crank case contains two gallons of oil and is arranged so that any surplus may be drawn off immediately. The lubricator has a gauge glass that shows the quantity of oil supplied at all times, and which is always in view of the operator.
A make and break system (low tension) furnishes the ignition spark, which is supplied with current by a Bosch low tension magneto under normal running conditions, and a battery for starting and for use when the magneto fails. The magneto is of course gear driven so that its armature has a fixed relation with the piston position. The igniters of either cylinder may be easily removed for examination by simply unscrewing two nuts.
Oil is used as a medium for carrying heat from the cylinder walls to the radiator. In the construction of the cooler the company have followed new principles, thus accomplishing the desired result with a minimum amount of metal and liquid. There is no surplus of liquid, just enough oil being used to fill the cylinder jackets, radiator and circulation pipes. The oil is kept in a constant flow from the cylinders to the radiator and back to the cylinders by a large pump which is driven by a chain direct from the crank shaft. The radiator is self-contained and will hold the oil for an indefinite period.
The radiator is composed of a number of sections of pressed galvanized steel. Oil circulates freely within the sections and the air is drawn round the outside. There is a constant flow of oil inside and a constant current of air outside.
The engine is provided with a smooth-working, efficient friction clutch, which is easily handled by a platform lever and with little exertion on the part of the operator. The toggle bolts are adjustable so that any wear in the blocks can be taken up.
The clutch and brake are so connected that when the clutch is thrown out the brake is immediately applied and when thrown in the brake is released.