Preparation of Nitric Acid.
Whenever pure nitric acid was required, it was purified by distilling against a platinum dish and collecting the distillate in a smaller one of the same metal. The nitric acid used was dilute and free from chlorine.
Purification of Water.
The water used in this work was purified by distilling twice from an alkaline solution of potassium permanganate, always rejecting the first part of the distillate. Whenever water was needed in the preparation of a pure compound e.g. cadmium oxalate, oxalic acid, cadmium nitrate, etc., it was subjected to the additional process of being distilled against a large platinum dish which was kept cool by placing ice inside it.
Purification of Oxalic Acid.
Commercial oxalic acid was heated with a fifteen percent solution of hydrochloric acid until all was dissolved. The solution was then warmed for twenty four hours. On cooling, crystals of oxalic acid separated out and these were washed with a little cold water to remove the mother liquor. They were then dissolved in hot ninety-five percent alcohol and allowed to crystallize slowly on cooling. The acid was next crystallized from ether in which it is only sparingly soluble. After this it was boiled with water until the odor of ethyl acetate had disappeared. Finally it was recrystallized three times from water and dried in the air at ordinary temperatures.
Preparation of Cadmium Oxalate.
A weighed piece of cadmium was dissolved in nitric acid and the excess of acid evaporated off. The nitrite was then dissolved in a large quantity of water and an equivalent amount of oxalic acid in solution added. The oxalate separated in a few moments as a crystalline precipitate. It was collected on a porcelain filter and washed thoroughly to remove nitric acid and ammonium nitrate. A considerable amount of ammonium nitrate was formed during the solution of the cadmium in nitric acid. The oxalate was finally dried in an air-bath for fifty hours, at 150°C.
Procedure
Enough cadmium oxalate for a determination was placed in a weighing tube which had been tared against a similar vessel and dried at 150°C. until the weight remained constant. It was then poured into a weighed porcelain crucible. The tube and its tare were now dried again at the same temperature to constant weight in order to avoid any error resulting from moisture being absorbed by the cadmium oxalate which adhered to the weighing-glass. The crucibles used in these determinations were arranged in the same manner as those employed by Morse and Jones in their work on this method. A small porcelain crucible on whose edge were placed three short platinum wires bent in the shape of the letter U, was placed in a larger porcelain crucible. The platinum wires prevented the lid from sticking to the crucible after heating and also allowed the products of decomposition to escape. The glaze was removed from the outside of the larger crucible with hydrofluoric acid to avoid sticking when heated to a high temperature. A second pair of crucibles arranged in the same manner was tared against the first one and in all cases treated like it. After the oxalate had been poured into the weighed crucible, it was decomposed by placing the crucible with its contents in a cylindrical asbestus covered air-bath, and slowly raising the temperature until the mass beams uniformly brown in color. In the last five determinations, the temperature was not allowed to exceed 300°C and after from forty to eighty hours the loss in weight was about ninety percent of the amount calculated for complete decomposition. In the first four the temperature was much higher and the time employed shorter. After the oxalate had been thus treated nitric acid was added and the contents of the crucible dissolved completely. The crucible was then transferred to a bath constructed by placing a larger porcelain crucible in a still larger one of iron and filling the intervening space with sand. It was slowly heated until the nitric acid had all evaporated and the dry nitrate began to give off red fumes. The crucibles were then removed to a similar bath containing iron filings instead of sand. This bath was heated by means of a single burner as long as red fumes were observed, and then for about five hours with a triple burner. Finally, the crucibles were transferred to a nickel crucible in the bottom of which a plate of unglazed porcelain was placed. The nickel crucible which had previously been set tightly into a hole cut in an asbestos board was then heated over the blast lamp for two hours. After this the porcelain crucible and contents were weighed and then reheated for half hour periods as before until three successive weighings remained constant. This usually required from three to four hours of blasting. In all determinations, the resulting product was tested for oxides of nitrogen with potassium iodide, starch and hydrochloric acid, but none was found. All weighings were reduced to the vacuum standard on the assumption of 8.4 for the Sp. Gr. of brass, 21. for platinum, 3.31 for the oxalate and 8.15 for cadmium oxide. The results are: