Block devices must be accessed in larger units called blocks, which contain a number of characters. Your hard disk is a block device.
You can read and write device files just as you can from other kinds of files, though the file may well contain some strange incomprehensible-to-humans gibberish. Writing random data to these files is probably a bad idea. Sometimes it’s useful, though. For example, you can dump a postscript file into the printer device /dev/lp0 or send modem commands to the device file for the appropriate serial port.
/dev/null
/dev/null is a special device file that discards anything you write to it. If you don’t want something, throw it in /dev/null. It’s essentially a bottomless pit. If you read /dev/null, you’ll get an end-of-file (EOF) character immediately. /dev/zero is similar, except that you read from it you get the \0 character (not the same as the number zero).
Named Pipes (FIFOs)
A named pipe is a file that acts like a pipe. You put something into the file, and it comes out the other end. Thus it’s called a FIFO, or First-In-First-Out, because the first thing you put in the pipe is the first thing to come out the other end.
If you write to a named pipe, the process that is writing to the pipe doesn’t terminate until the information being written is read from the pipe. If you read from a named pipe, the reading process waits until there’s something to read before terminating. The size of the pipe is always zero: It doesn’t store data, it just links two processes like the shell |. However, because this pipe has a name, the two processes don’t have to be on the same command line or even be run by the same user.
You can try it by doing the following:
cd; mkfifo mypipe
Makes the pipe.