Let’s assume you have a system with two SCSI disks, one at SCSI address 2 and the other at SCSI address 4. The first disk (at address 2) is then named sda and the second sdb. If the sda drive has three partitions on it, these will be named sda1, sda2, and sda3. The same applies to the sdb disk and its partitions. Note that if you have two SCSI host bus adapters (i.e., controllers), the order of the drives can get confusing. The best solution in this case is to watch the boot messages, assuming you know the drive models.
2.3.5 Recommended Partitioning Scheme
As described above, you should have a separate smaller root partition and a larger /usr partition if you have the space. For most users, the two partitions initially mentioned are sufficient. This is especially appropriate when you have a single small disk, because creating lots of partitions can waste space.
In some cases, you might need a separate /usr/local partition if you plan to install many programs that are not part of the Debian distribution. If your machine will be a mail server, you may need to make /var/spool/mail a separate partition. Putting /tmp on its own 20 to 32MB partition, for instance, is a good idea. If you are setting up a server with lots of user accounts, it’s generally good to have a separate, large /home partition to store user home directories. In general, the partitioning situation varies from computer to computer depending on its uses.
For very complex systems, you should see the Multi Disk HOWTO[[8]]. It contains in-depth information, mostly of interest to people setting up servers.
[8] http://metalab.unc.edu/LDP/HOWTO/Multi-Disk-HOWTO.html
Swap partition sizes should also be considered. There are many views about swap partition sizes. One rule of thumb that works well is to use as much swap as you have system memory, although there probably isn’t much point in going over 64MB of swap for most users. It also shouldn’t be smaller than 16MB, in most cases. Of course, there are exceptions to these rules. If you are trying to solve 10,000 simultaneous equations on a machine with 256MB of memory, you may need a gigabyte (or more) of swap space.
As an example, consider a machine that has 32MB of RAM and a 1.7GB IDE drive on /dev/hda. There is a 500MB partition for another operating system on /dev/hda1. A 32MB swap partition is used on /dev/hda3 and the rest, about 1.2GB, on /dev/hda2 is the Linux partition.
2.3.6 Partitioning Prior to Installation
There are two different times that you can partition: prior to or during the installation of Debian. If your computer will be solely dedicated to Debian you should partition during installation as described in section 3.5 on page [*]. If you have a machine with more than one operating system on it, you should generally let the other operating system create its own partitions.