The Rogers Locomotive and Machine Works and the New Jersey Locomotive and Machine Works, both of Paterson, New Jersey, in the early 1860’s began building Moguls; these are known to have had Bissell trucks. Other builders followed their example, so that by the 1870’s 2-wheel trucks had become relatively common.
It should be noted that the 2-wheel truck was not an absolute success until it was equalized with the front driving axle. This arrangement was perfected in 1864 by William S. Hudson, but before describing his invention it will be helpful to discuss several earlier attempts to equalize pony trucks with the drivers.
In 1857 John P. Laird, then master mechanic of the Marietta and Cincinnati Railroad, rebuilt an old Niles 8-wheeler into a curious 2-6-0 on which only the two rear driving wheels were coupled. The front driver was driven by a chain and sprocket, and the pilot wheels were equalized with the front driving axle. The success or failure of the arrangement has not been definitely determined, but whatever the outcome, Laird continued his experiments when he became superintendent of motive power for the Pennsylvania Railroad in 1862. He abandoned the chain drive for a more conventional arrangement of side rods, but the truck and his plan of equalization were much the same as that tried earlier. Laird used two equalizing levers, attached at one end to the front spring hangers and at the other to the truck, [p130] but in a way to allow the truck to swing horizontally. The fulcrum for each lever was mounted on the underside of the front frame rail. A number of old 8-wheel Baldwin flexible-beam engines and several Winans’ Camels were rebuilt in this way. One of these is shown in [figure 8]. Laird, however, eventually became dissatisfied with his arrangement and re-equipped the engines with Bissell trucks.
LOCOMOTIVE ENGINE SAFETY TRUCK CO.
OF NEW YORK.
Proprietors of the following Letters Patent granted to Levi Bissell, Aug. 4, 1857, Nov. 2, 1858 (extended Nov. 2, 1872); A. W. Smith, Feb. 11, 1862; D. R. Pratt. Oct. 16, 1860; W. S. Hudson, April 5, 18?? and May 10, 1864.
DRAWINGS FURNISHED AND LICENSES GRANTED ON APPLICATION.
| A. F. SMITH, President. | M. F. MOORE, Sec’y and Agent |
| ALBERT BRIDGES. Treas. | No 46 Cortlandt st. N. Y. |
Figure 12.—Notice of the Locomotive Safety Truck Company listing the patents held by it. From Railroad Gazette, March 3, 1876.
John L. Whetstone on April 10, 1860, obtained U.S. patent 27850, which strikingly anticipated the plan Hudson was to develop four years later.[22] Whetstone did not use a Bissell truck and was in fact more concerned in relieving the excess weight, often a 50% overload, from the front axle of 0-6-0 locomotives and in distributing a portion of that weight to a pony truck. His arrangement may be readily understood from the patent drawing in [figure 9]. Probably the best features of the design was the transverse H-beam that connected the spring hangers to the truck frame, which in this case also served as the equalizing lever (note that the ball “C” acts as the fulcrum).