Fig. 318.—Netting needle for seal net.
For making the seal nets a very large needle is used. The one in the collection, No. 56581 [102], Fig. 318, from Utkiavwĭñ, is 20½ inches long and only 1½ wide. It is made of two nearly equal pieces of antler, which are nearly flat, and lap over each other about 3¾ inches near the middle. They are strongly fastened together by five whalebone stitches, one at each corner of the splice and one in the middle. The corner stitches run round the edge of the two parts, and through a hole through both parts. The prongs are stout and curved, nearly meeting at the tips. They are about 3 inches long. The lateral distortion appears to be due to warping.
A peculiar netting needle is shown in Fig. 319 (No. 89429 [1333], from Utkiavwĭñ), which is new and rather carelessly made from very coarse walrus ivory. The tips of the prongs, after nearly meeting, diverge again in the form of the letter U. This needle, which is 9½ inches long, was said by the maker to be of the pattern used by the “Kûñmû´d’lĭñ.” There are no specimens resembling it in the museum collections, though it curiously suggests certain implements from Norton Sound, labeled “reels for holding fine cord,” consisting of slender rods of antler, terminating at each end in similar shallow U-shaped forks.
Fig. 319.—Netting needle.
The mesh stick (kú´brĭn) belonging to the large netting needle, No. 56581 [102], may be taken as the type of this implement. It is a piece of the hard outside tissue of a reindeer antler. The three notches on the lower edge of the haft are for the fingers. The incised line along one face of the blade is probably a mark to which the twine is to be drawn in making a mesh. The blade is just the proper length, 7½ inches, for the large mesh of the seal net. The remaining four mesh sticks are all small, and intended for making fish nets. Three are of reindeer antler and the fourth of hard bone, with a wooden haft.