Now comes a point that should not be overlooked: lay a course, buts out, lapping half way from heads to band on outside course; then lap half and lay to center.
The reason for laying the buts of second course half way from heads to band is to give the buts of the next outside course above a chance to rest firmly on the course below, leaving no unoccupied space; if the buts of second course were laid out to the band of outside course, then the next outside course above, being drawn in, would rest one-third of the way from band to but, on the buts of the course below, leaving a space for rain to drive in and wet the stack. Draw in outside course rapidly (See figure 6); lay buts of second course half way from head to band on outside course as long as stack top is large enough; keep middle well piled up.
A stack can be drawn in very rapidly, without danger of taking in water from a protracted rain, even if the outside of the stack grows green, no sheaf will be found wet above the band, and the middle of stack dry, for the buts of outside course will form a thatch roof to protect the stack.
The placing of a few top bundles is a matter of small importance. If a stack has been properly built it will receive but little injury if top bundles should blow off. A strand or two of wire, with sticks or stones at the ends to weight them down, will usually hold the top in place.
RECAPITULATION.
The first load being built straight up and flat on top forms a firm and secure base on which to build the upper structure.
Laying out or putting in the bulge.—This is the most important part of the stack, for it contains the greater part of the grain; by laying out and keeping the stack flat, the work can be done rapidly, and when the stack settles the buts will hang down, for there is nothing to hold them up.
FIGURE SEVEN.
Filling the middle corresponds to putting rafters on a building to support the roof.