From a florist’s supply-house purchase one hundred and fifty sheets of tin-foil seven by nine inches, or sheets that will cut to that size without waste; also ten or twelve extra sheets for strips. At a paper supply-house obtain some clear, thin, tough paper about the thickness of good writing-paper. Be careful to reject any sheets that are perforated or have any fine holes in them. The sheets should be eight by ten inches, or half an inch larger all around than those of the tin-foil. The paper must be thoroughly soaked in hot paraffine to make it moisture-proof and a perfect non-conductor. This is done by placing about two hundred sheets on the bottom of a clean tin tray, or photographic developing-dish of porcelain. Don’t use glass or rubber. After placing some lumps of paraffine on the paper, put the tray in an oven so as to dissolve the paraffine and thoroughly soak the paper.
Open the oven door and, with a pin, raise up the sheets one at a time, and draw them out of the liquid paraffine. As soon as it comes in contact with cool air the paraffine solidifies and the sheet of paper becomes stiffened. Select each sheet with care, so that those employed for the condenser are free from holes or imperfect places.
From pine or white-wood, a quarter of an inch in thickness, cut two boards, eight by ten inches, and give them several good coats of shellac.
To build up the condenser, lay one board on a table and on it place two sheets of paraffined paper. On this lay a sheet of tin-foil, arranging it so that half an inch of paper will be visible around the margin. From the odd sheets of tin-foil cut some strips, one inch in width and three inches long. Place one of these strips at the left end of the first sheet of foil, as shown at [Fig. 19]. Over this lay a sheet of the paraffined paper, then another sheet of the foil. Now on this second sheet of foil lay the short strip to the right end, and so proceed until all the foil and paper is in place, arranging each alternate short strip at the opposite end. Care must be taken to observe this order if the condenser is to be of any use.
When the last piece of foil is laid on, with its short strip above it, add two or three thicknesses of paper, and then the other board. With four screw-clamps, one at each corner, press together the mass of foil, paper, and boards as closely as possible, then bind the boards about with adhesive tape, or stout twine, and release the clamps. Attach all the projecting ends of foil at one side by means of a binding-post, and those at the other end with another binding-post. The complete condenser will then appear as shown in [Fig. 20].
When in operation one wire leading from the secondary coil should be connected with a binding-post of the condenser, so that it is in series.
The object of the condenser is to increase the efficiency of induction, and it should be made in proportion to the size of the induction-coil with which it is to be employed.