Fig. 2684.
Fig. 2685.
The ends of the belt should be cut quite square, and at a right angle to the edges, so that when the two ends are drawn together by the lace the edges of the belt will remain straight, and not curved, as they would do if either end of the belt were not cut at a right angle. Suppose, for example, that the ends of a belt were cut aslant, as in [Fig. 2684], when laced up the edge of the belt would come as in [Fig. 2685].
Fig. 2686.
The holes must be punched exactly opposite to each other, or lacing the belt will bring the edges out of fair, as shown in [Fig. 2686], the tension of the lace drawing the holes opposite to each other, irrespective of where the edges of the belt will come. If some of the holes are opposite and others are not, the latter will throw the edges of the belt out of line to some extent, especially if the lace is first entered in the holes that are not opposite, because, in that case, drawing the lace tight at once throws the belt edges out, and the subsequent lacing has but a limited effect in correcting the error, unless, indeed, the majority of the holes are opposite, and but one or two are out of line.
The lace should be drawn sufficiently tight to bring the ends of the belt firmly together, and should be laced with an even tension throughout, and for a belt doing heavy duty should have its ends tied in a knot at the back, and in the middle of the belt.