Fig. 552.
[Figs. 551] and [552] represent a plan and a side view of the other half of the lathe in operation upon the same crank shaft, which is again shown in dotted lines.
Referring now to the general construction of the lathe, the headstock or live spindle has a front journal bearing 18 inches diameter and 24 inches long, and a back bearing 12 inches diameter and 15 inches long, the bearings being parallel. The driving cone has five changes of speed for a 6-inch belt, and is carried on an independent spindle. The cone is turned inside as well as outside, so as to be in balance at high speeds.
The face plate is 12 feet diameter, cast with internal gear at the back. It is provided with T-slots and square holes for fixing work. It is bolted to a large flange in one piece with the spindle, and fitted with four steel expanding gripping jaws worked with screws and toothed blocks. These are for doing chuck work, or for gripping work to be driven, as the collars of propeller or crank shafts, or work of a similar character. By the system of gearing adopted, when desired, the face plate can be revolved almost free, which facilitates balancing for turning crank shafts, as well as other operations. The thrust against the live spindle is taken by an adjustable steel tail piece.
The beds are double, 10 feet in width over all, the sections being joined together by massive ground plates and bolts. They are made with square lips to resist the upward strain of cutting. The front bed is fitted with two saddles, each carrying a compound slide rest having the following movements: First, screw-cutting, by means of a leading screw, situated inside the bed, with a sliding disengaging nut and reversing motion for right or left-hand threads, or for instantaneously stopping the longitudinal movement of the saddle. This is accomplished by a set of clutch mitres placed inside the bed at headstock end, and actuated by a lever in front: Second, a self-acting surfacing motion to slide rest by means of a longitudinal shaft at the front of the bed, and clutch mitres for reversing the saddle screw.
Third, power motion for moving the saddles quickly to position along the bed. This is done through the fast and loose pulleys at the headstock end of lathe.
Fourth, hand rack motion to saddle. The back bed is fitted with two saddles, each carrying a pillar rest, fitted for all movements in plain turning like the front rests, and also with swiveling motion for corner turning.
The tailstock has a spindle 9 inches diameter. It is fitted in Vs on the bed, and held down by three T-head bolts on each side. The top section is adjustable for turning tapers. It is moved along the ways by engaging a nut with the main screw. An end-cutting rest is fitted to the tailstock, which is adapted for operating on flanged couplings and similar work.
There is a separate set of change wheels for each saddle, so arranged as to cut standard pitches up to 3-inch pitch, and for self-acting feeds down to 50 per inch. By this means, when both tools are in operation on a piece of work, one tool may be used with coarse feed for roughing out, while the other may be taking a fine or finishing cut either on the same or a different part of the piece; or one tool may be cutting towards and the other from the face plate, always maintaining the balance of a front and back cut.