a—Bias Facing; b—Band on Gathers; c—Corded edge.
For flannel, pleating or gathers may be used to put fullness into a band. Two rows of gathering threads should be used and the stitches should not be too fine. The band should be made of cotton or at least lined with it to avoid clumsiness and prevent shrinking. Ruffles are set in hems, etc., in the same manner.
DRAW TAPE FINISH FOR UNDER SKIRT
Drawing Tapes
In finishing the top of an underskirt, many like to dispense with the placket and fitted band. This may be done by using drawing tapes at the back. The upper edge is faced with a piece of material which should be bias in front to accommodate it to the curve, but may be straight across the back. Work a button hole at each side of the back, insert a tape through one button hole and draw it over an inch beyond the opposite one and fasten securely by two lines of stitching across the tape. A second tape is put through the other button hole and fastened in the same way. By pulling the tape on each side the fullness may be adjusted.
Bias Facings
All facings around curves, such as arm holes and neck, should be a true bias which is cut by holding the warp threads diagonally across the woof threads. These strips for facings, pipings, ruffles, etc., should be cut exactly even in width. All bands, ruffles, etc., of serge, twilled, or diagonal materials should be cut across the twill and not with it, in order to have the ruffle hang well.