LINEN PATCH; CROSS STITCH INITIAL
Onset Patch
The onset patch is used on lined garments and linings. The patch should be rectangular and larger than the worn place. Fold the four edges on the wrong side of the patch, place the patch with its wrong side on the right side of the garment directly over the center of the hole. This will bring the folded edges of the patch between the two pieces of cloth and both right sides towards the worker. Do not baste, but pin carefully. After the garment has been folded back until there are two folded edges side by side, overhand the seam with even slanting stitches. See that the corners are well sewed, that warp and woof threads run in the same direction, that pattern and stripes match.
RIGHT SIDE OF FLANNEL PATCH
Edge cat stitched but not turned, back cat stitched in the same way.
The worn part of the garment under the patch is cut away, leaving one-fourth of an inch on the three sides. Cut the corners diagonally and turn back the edge quarter of an inch, overcast and press. If this patch is sewed on a lining, the worn part is not cut away. If this patch is used to repair skirts near the band, only three sides are oversewed, the upper edge should be gathered into the band. A large patch is less conspicuous than a small one.
Patch for Trowsers
An onset patch may be used for the seats of trousers by shaping the patch like the pieces on the seats of bicycle trousers and stitching on the machine. Heavy cloth will need no inturned edges. The same precautions are necessary regarding warp and woof, pattern, etc.