Textiles and Clothing

by Kate Heintz Watson

Too much care cannot be taken in arranging the pattern of the sleeve according to the thread of the goods. Especially is this the case in the two-piece or coat sleeve. Generally the top part of the outside seam and the lower part of the same side should be placed at the edge or fold of the goods, so that the two run in the same straight line. In all cases, the foundation sleeve or lining should be cut and fitted before the outer portion is adjusted. Ample time should be given to the fitting and basting of the sleeve. The "set" of the sleeve is very often unsatisfactory because the cutting and original basting was done in a careless manner. Remember that greater care is required in sleeve making than in any part of the garment. Each sleeve is complete in itself and one must not deviate from the other in size, arrangement or ornament, or general appearance. They should be cut, basted and fitted alike and if the arms differ in size or length the sleeves must be so adjusted as to conceal the inequality.

The sleeves should be made at the same time and before the cuffs, then the cuffs, puffs, or whatever special trimming is to be applied to them should be put on both sleeves at the same time. If the second sleeve is not made or trimmed until after the first is finished, it will be much more difficult to secure exactly the same effect. If it is impossible to complete both sleeves at one time, make the sleeves one day and the cuffs or trimming the next day.

In making the coat sleeves the general methods are the same, but each season brings out new styles which the maker will have to understand before proper making and finishing can be acquired. Always master the simple and standard patterns and the minor changes dictated by fashion—new fancies and effects—will not be difficult to acquire after a little experience has been gained.

The lining for both sleeves should be fitted and the outside cut by them.

Joining the Parts

After economical cutting, trace the seams carefully, and baste the outside to the lining, basting both uppers before the under sections. Join the under and upper parts by pinning and basting, the outside seam first, beginning in the middle of the sleeve and working toward each end. The outside seams should be begun at the notch at the elbow, working toward each end. Where the sleeve calls for gathering the fullness should be distributed between the notches and the two portions of the sleeve should be secured at this point, before or after basting the upper or lower portions of each sleeve.

FINISHING OF SEAMS

Notched at Curves and Bound or Overcast.

Stitch the seams just outside the basting, then remove the line of basting along the seam and press. Trim off all rough edges. The inside seam is opened and notched at the bend of the elbow and an inch or two above and below and bound with silk binding ribbon or evenly overcast with twist or mercerized cotton.